Difficulty

Easy

Steps

6

Time Required

                          5 - 15 minutes

Sections

3

  • Battery
  • 2 steps
  • Blaster Casing
  • 3 steps
  • O-Ring and Plunger
  • 1 step

Flags

1

Grammar Police

Embrace your inner English teacher and help improve this guide’s grammar!

  • BackNerf N-Strike Firestrike

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove battery cover
  • Use a #1 Phillips screwdriver to remove the 10 -mm screw that secures the battery plate, then remove the battery cover using your hands.

Use a #1 Phillips screwdriver to remove the 10 -mm screw that secures the battery plate, then remove the battery cover using your hands.

1024

Step 2

  • Slide out the two AAA batteries using your fingers.

Slide out the two AAA batteries using your fingers.

Step 3

              Blaster Casing
  • Remove the seven 10-mm black Phillips screws from the blaster casing with a #1 Phillips Screwdriver.

Remove the seven 10-mm black Phillips screws from the blaster casing with a #1 Phillips Screwdriver.

Step 4

  • Slowly pull apart the blaster casing, starting at the battery location.
  • Keep pulling apart slowly until it separates completely. Be cautious as to not send the internal components flying.

Slowly pull apart the blaster casing, starting at the battery location.

Keep pulling apart slowly until it separates completely. Be cautious as to not send the internal components flying.

Step 5

  • For reassembly, ensure that the chrome nut gets put back in the proper location, signified by the red box.
  • For reassembly, ensure that all the parts are lined up correctly on the dowels, signified by the four orange boxes.
  • For reassembly, note the location of the springs as highlighted in the second photo.

For reassembly, ensure that the chrome nut gets put back in the proper location, signified by the red box.

For reassembly, ensure that all the parts are lined up correctly on the dowels, signified by the four orange boxes.

For reassembly, note the location of the springs as highlighted in the second photo.

Step 6

              O-Ring and Plunger
  • Without removing the barrel assembly, tilt it slightly upwards.
  • Slide the plunger out from the air chamber.

Without removing the barrel assembly, tilt it slightly upwards.

Slide the plunger out from the air chamber.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 1 other contributor 


                    Clovis Jahan

Member since: 04/23/2015

200 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 15-6, Amido Spring 2015                        

                                                  Member of Cal Poly, Team 15-6, Amido Spring 2015 



                    CPSU-AMIDO-S15S15G6                     


                                            3 Members                     


                                            8 Guides authored