Difficulty

Moderate

Steps

6

Time Required

                          20 minutes

Sections

2

  • Nerf N-Strike Elite Retaliator Case Disassembly
  • 5 steps
  • Trigger Spring
  • 1 step

Flags

1

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackNerf N-Strike Elite Retaliator

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Modifying your blaster is not advised and may void the manufacturer’s warranty in certain states.

This blaster is equipped with a rifled barrel for maximum performance.

What you need

Step 1

              Case Disassembly
  • While holding the blaster, rotate the barrel assembly in the counter-clockwise direction and pull away from the blaster.

While holding the blaster, rotate the barrel assembly in the counter-clockwise direction and pull away from the blaster.

1024

Step 2

  • Remove the stock of the blaster by pushing the orange tabs downward while pulling the stock away from the blaster.

Remove the stock of the blaster by pushing the orange tabs downward while pulling the stock away from the blaster.

Step 3

  • Remove the magazine from the blaster by forcing the sliding mechanism backwards, pushing the orange tabs downward, and pulling the magazine away.

Remove the magazine from the blaster by forcing the sliding mechanism backwards, pushing the orange tabs downward, and pulling the magazine away.

Step 4

  • Remove the stock attachment point by removing the two 8mm Phillips head screws.

Remove the stock attachment point by removing the two 8mm Phillips head screws.

Step 5

  • Remove the eleven 8mm and two 10mm Phillips head screws from the left side of the blaster, and carefully remove the outer casing.
  • Two of the screws must be removed with the sliding mechanism in the forward position. Another two must be removed with the sliding mechanism in the back position.
  • There are several springs that may become displaced during this procedure. Proceed with the utmost caution.

Remove the eleven 8mm and two 10mm Phillips head screws from the left side of the blaster, and carefully remove the outer casing.

Two of the screws must be removed with the sliding mechanism in the forward position. Another two must be removed with the sliding mechanism in the back position.

There are several springs that may become displaced during this procedure. Proceed with the utmost caution.

Step 6

              Trigger Spring
  • Carefully pull the orange trigger upward and backward to remove it from the blaster.
  • This component is under spring pressure. Wear appropriate personal protective equipment to shield your eyes.
  • Remove the spring from the rear of the trigger.

Carefully pull the orange trigger upward and backward to remove it from the blaster.

This component is under spring pressure. Wear appropriate personal protective equipment to shield your eyes.

Remove the spring from the rear of the trigger.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    ericharman

Member since: 03/02/2016

1,380 Reputation

                                      5 Guides authored                  



                       Badges:
                       20







                                                        +17 more badges

Kelvin Mead - Jan 4, 2021

Reply

ok, taken the spring out. now what?