Difficulty
Easy
Steps
5
Time Required
5 - 10 minutes
Sections
1
- Barrel
- 5 steps
Flags
0
BackNerf N-Strike Elite Retaliator
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Modifying your blaster is not advised and may void the manufacturer’s warranty in certain states.
This blaster is equipped with a rifled barrel for maximum performance.
What you need
Step 1
Remove Barrel
- While holding the blaster, rotate the barrel assembly in the counter-clockwise direction and pull away from the blaster.
While holding the blaster, rotate the barrel assembly in the counter-clockwise direction and pull away from the blaster.
1024
Step 2
Remove Grip
- Slide the hand grip assembly toward the end of the barrel and off the barrel assembly.
- This may require more force than anticipated.
Slide the hand grip assembly toward the end of the barrel and off the barrel assembly.
This may require more force than anticipated.
Step 3
Remove Barrel Cap
- Disassemble the orange barrel cap by removing two 8mm Phillips screws.
Disassemble the orange barrel cap by removing two 8mm Phillips screws.
Step 4
Disassemble Barrel Assembly
- Disassemble the barrel assembly by removing four 8mm Phillips screws from the blue barrel housing.
- There are springs that may become displaced when the barrel housing is removed. Proceed with caution.
Disassemble the barrel assembly by removing four 8mm Phillips screws from the blue barrel housing.
There are springs that may become displaced when the barrel housing is removed. Proceed with caution.
Step 5
Replace Barrel
- Remove the orange barrel from the assembly.
Remove the orange barrel from the assembly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 6 other contributors
ericharman
Member since: 03/02/2016
1,380 Reputation
5 Guides authored
Badges:
20
+17 more badges