Difficulty
Moderate
Steps
9
Time Required
35 minutes
Sections
1
- Spring Mechanism
- 9 steps
Flags
0
BackNerf N-Strike Deploy CS-6
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Spring Mechanism
- Proceed to take out hidden screws as shown.
- Device must be collapsed in order to take out the hidden screws. Hidden screws measure out to 1.7 cm.
Proceed to take out hidden screws as shown.
Device must be collapsed in order to take out the hidden screws. Hidden screws measure out to 1.7 cm.
1024
Step 2
- Proceed to take out all the necessary screws.
- On the top left corner of the orange pump, there is another screw that will need to be taken out. The majority of the screws measure out to 1.3 cm.
Proceed to take out all the necessary screws.
On the top left corner of the orange pump, there is another screw that will need to be taken out. The majority of the screws measure out to 1.3 cm.
Step 3
- Removal of the pump is needed in order to get to the spring mechanism.
- Locate the screws on the orange pump and proceed to take them out.
Removal of the pump is needed in order to get to the spring mechanism.
Locate the screws on the orange pump and proceed to take them out.
Step 4
- Once screws are removed from the pump part you can then remove the pump parts.
Once screws are removed from the pump part you can then remove the pump parts.
Step 5
- Once taken apart, the orange pump should be neatly placed on a safe surface.
Once taken apart, the orange pump should be neatly placed on a safe surface.
Step 6
- Top extension part can now be taken off.
- Once pulled apart, this is how the device should look.
- Highlighted parts with will fit together into the other highlighted parts.
Top extension part can now be taken off.
Once pulled apart, this is how the device should look.
Highlighted parts with will fit together into the other highlighted parts.
Step 7
- Locate your damage spring mechanism.
- Once located, you may now pull it away from the device.
Locate your damage spring mechanism.
Once located, you may now pull it away from the device.
Step 8
- Spring has a small hook on the right side & must be placed on yellow holder.
- Spring hook can be seen through same highlight whereas the yellow holder is located.
Spring has a small hook on the right side & must be placed on yellow holder.
Spring hook can be seen through same highlight whereas the yellow holder is located.
Step 9
- Place device cover back on.
- When trying to close the cover back on top, push spring from the left towards the right to adjust cover in place.
- You may use a screwdriver to pull the spring back as it is tad unpredictable in movement. May take a few times.
- The screwdrive, as shown, is pushed forward to be put back into place.
Place device cover back on.
When trying to close the cover back on top, push spring from the left towards the right to adjust cover in place.
You may use a screwdriver to pull the spring back as it is tad unpredictable in movement. May take a few times.
The screwdrive, as shown, is pushed forward to be put back into place.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Brenda
Member since: 09/28/2016
71 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
Eastern Washington University, Team 2-5, Mathisen Fall 2016
Member of Eastern Washington University, Team 2-5, Mathisen Fall 2016
EWU-MATHISEN-F16S2G5
4 Members
4 Guides authored
