Difficulty
Easy
Steps
14
Time Required
10 - 20 minutes
Sections
1
- Spring
- 14 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackNerf N-Strike Elite Mega Magnus
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Spring
- Start by removing the (4) exterior Phillips screws from the shell of the gun with a #1 Phillips Screwdriver.
Start by removing the (4) exterior Phillips screws from the shell of the gun with a #1 Phillips Screwdriver.
1024
Step 2
- Pulling upward from the rest of the shell, carefully remove the half of the slide facing you.
Pulling upward from the rest of the shell, carefully remove the half of the slide facing you.
Step 3
- On the same side, remove all (9) screws from the body of the blaster as shown.
On the same side, remove all (9) screws from the body of the blaster as shown.
Step 4
- Lift up on the top half of the shell with deliberate force. This should reveal the internals.
Lift up on the top half of the shell with deliberate force. This should reveal the internals.
Step 5
- Remove the screws from the trigger mechanism and lift it upward
Remove the screws from the trigger mechanism and lift it upward
Step 6
- Locate the small grey piece under the plunger tube and remove the screw.
Locate the small grey piece under the plunger tube and remove the screw.
Step 7
- Locate the screws on the return spring. Using a counterclockwise rotation, remove both of the screws.
Locate the screws on the return spring. Using a counterclockwise rotation, remove both of the screws.
Step 8
- Using a small tool, carefully remove the spring from its pegs.
Using a small tool, carefully remove the spring from its pegs.
Step 9
- Locate the screws behind the dart pusher mechanism. Carefully remove each screw.
Locate the screws behind the dart pusher mechanism. Carefully remove each screw.
Step 10
- Pull upwards on the dart pusher and spring to remove them.
Pull upwards on the dart pusher and spring to remove them.
Step 11
- Lift up on the magazine plate in order to remove it.
Lift up on the magazine plate in order to remove it.
Step 12
- Pull upward on the dart lip and it will lift off.
Pull upward on the dart lip and it will lift off.
Step 13
- Lift the left side of the plunger tube from its peg and the rest will slide off the spring peg.
Lift the left side of the plunger tube from its peg and the rest will slide off the spring peg.
Step 14
- Slide the spring off its peg. If the spring is damaged, replace it.
Slide the spring off its peg. If the spring is damaged, replace it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 5 other contributors
Averi Fletcher
Member since: 06/01/2016
135 Reputation
1 Guide authored
Badges:
7
+4 more badges
Team
Central Coast New Tech High, Team 5-5, Rushing Spring 2016
Member of Central Coast New Tech High, Team 5-5, Rushing Spring 2016
CCNTH-RUSHING-S16S5G5
2 Members
1 Guide authored