Difficulty

Moderate

Steps

6

Time Required

                          3 minutes

Sections

3

  • Back Panels of Neato XV-21
  • 3 steps
  • Battery
  • 1 step
  • Fan
  • 2 steps

Flags

0

  • BackNeato XV-21

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panels of Neato XV-21
  • Flip the Neato on its back so the bottom is exposed
  • Unscrew the seven screws.

Flip the Neato on its back so the bottom is exposed

Unscrew the seven screws.

1024

Step 2

  • Lift the panels to reveal the batteries, brush and fan
  • There should be little to no resistance during this step, do not continue if the pieces do not separate easily

Lift the panels to reveal the batteries, brush and fan

There should be little to no resistance during this step, do not continue if the pieces do not separate easily

Step 3

  • The Neato’s core components are now exposed and ready to be cleaned and/or replaced.

The Neato’s core components are now exposed and ready to be cleaned and/or replaced.

Step 4

              Battery
  • Pinch and pull the white connector to disconnect the battery from the device
  • Failure to complete this step could cause electric shock or later complications
  • Lift and remove the battery from the cavity
  • If replacing the battery, make sure to use proper disposal methods.

Pinch and pull the white connector to disconnect the battery from the device

Failure to complete this step could cause electric shock or later complications

Lift and remove the battery from the cavity

If replacing the battery, make sure to use proper disposal methods.

Step 5

              Fan
  • Pinch the white connectors to disconnect the fan from the robot, as previously done with the batteries
  • Once the wires are disconnected lift the fan from the cavity

Pinch the white connectors to disconnect the fan from the robot, as previously done with the batteries

Once the wires are disconnected lift the fan from the cavity

Step 6

  • Once the fan has been removed you can take a damp cloth and clean the cavity before attaching the new device

Once the fan has been removed you can take a damp cloth and clean the cavity before attaching the new device

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 4 other contributors 


                    Taylor Shedd

Member since: 09/25/2017

170 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       University of North Texas, Team S2-G3, Thompson Fall 2017                        

                                                  Member of University of North Texas, Team S2-G3, Thompson Fall 2017 



                    UNT-THOMPSON-F17S2G3                     


                                            4 Members                     


                                            6 Guides authored