Neato Botvac D8000 Top Face Panel Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          20 minutes            

Sections

1

• Top Face Panel
• 6 steps

Flags

0

• BackNeato Botvac D8000

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Top Face Panel               

• Grab the rear bumper with both hands on either side.

Grab the rear bumper with both hands on either side.

1024

Step 2

• Firmly pull the bumper forward at a steady pace.
• When pulling the bumper forward avoid being too rough because the bumper might break.

Firmly pull the bumper forward at a steady pace.

When pulling the bumper forward avoid being too rough because the bumper might break.

Step 3

• Looking from above, remove the two 11mm screws with a Torx T10 screwdriver.

Looking from above, remove the two 11mm screws with a Torx T10 screwdriver.

Step 4

• Place the robot on its back and remove the six 11mm screws using a Torx T10 screwdriver.

Place the robot on its back and remove the six 11mm screws using a Torx T10 screwdriver.

Step 5

• Push the clips, located in the back side, inward.
• Gently lift up the top cover until you can see the wires. Then gently un-clip all the wires.
• When you lift the top cover be careful because the wires are thin and fragile.

Push the clips, located in the back side, inward.

Gently lift up the top cover until you can see the wires. Then gently un-clip all the wires.

When you lift the top cover be careful because the wires are thin and fragile.

Step 6

• Once you have carefully removed the wire clip; you can fully remove the top cover.

Once you have carefully removed the wire clip; you can fully remove the top cover.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Ruth Lopez                     

Member since: 03/22/2018

280 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Sam Houston State, Team S17-G6, Blackburne Spring 2018                        

                                                  Member of Sam Houston State, Team S17-G6, Blackburne Spring 2018 



                    SHSU-BLACKBURNE-S18S17G6                     


                                            4 Members                     


                                            10 Guides authored