Difficulty
Easy
Steps
2
Time Required
Suggest a time??
Sections
1
- Rear Bumper
- 2 steps
Flags
0
BackNeato Botvac 80
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Step 1
Rear Bumper
- Grab the rear bumper with both hands on either side.
Grab the rear bumper with both hands on either side.
1024
Step 2
- Pull the left and right sides away from the machine to unclip the bumper. This requires that you bend the plastic a little bit. Unclip one side a little bit and allow the prong to rest on the side of the machine. Then unclip the other side and pull off the bumper parallel to both sides
Pull the left and right sides away from the machine to unclip the bumper. This requires that you bend the plastic a little bit. Unclip one side a little bit and allow the prong to rest on the side of the machine. Then unclip the other side and pull off the bumper parallel to both sides
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Brandon Blank
Member since: 02/02/2017
675 Reputation
5 Guides authored
Badges:
11
+8 more badges
Team
USF Tampa, Team 17-5, Blackwell Spring 2017
Member of USF Tampa, Team 17-5, Blackwell Spring 2017
USFT-BLACKWELL-S17S17G5
3 Members
12 Guides authored
Sanjukta - Jul 14, 2018
Reply
Is the rear bumper a single piece that is both upper and lower part joined?
