Neato Botvac 80 Brush Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          1 minute

Sections

Brush
3 steps

Flags

BackNeato Botvac 80
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

This guide instructs you to detach the brush guard; this is intended to prevent damage to the actual brush and brush motor. Then replacement of the brush will be simple!

What you need

Step 1

              Remove Small Wheels

Note: This step is not necessaryto remove the brush guard. Only do this is the wheels are not spinning correctly To begin, turn the Neato Botvac 80 upside down and locate the brush. Remove the 4 screws highlighted in red, and remove the cover. This releases the 2 small wheels, where you can remove the hair that gets tangled in them.
You will need to remove the four 10mm bolts with a T10 Torx screwdriver.

Note: This step is not necessaryto remove the brush guard. Only do this is the wheels are not spinning correctly To begin, turn the Neato Botvac 80 upside down and locate the brush. Remove the 4 screws highlighted in red, and remove the cover. This releases the 2 small wheels, where you can remove the hair that gets tangled in them.

You will need to remove the four 10mm bolts with a T10 Torx screwdriver.

1024

Step 2

Find the two inlays in front of the wheels and pull them to release the brush guard.

Find the two inlays in front of the wheels and pull them to release the brush guard.

Step 3

              Remove Brush

Remove brush by pulling out and to the side.
If you want to replace: repeat these steps in reverse with the new brush bar
If you want to clean: take the metal bearing off the side, remove the hair wrapped in the orange holder. With a scissors, cut the hair out of the brush roll. Re-insert the brushroll and re-install the brush guard

Remove brush by pulling out and to the side.

If you want to replace: repeat these steps in reverse with the new brush bar

If you want to clean: take the metal bearing off the side, remove the hair wrapped in the orange holder. With a scissors, cut the hair out of the brush roll. Re-insert the brushroll and re-install the brush guard

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Brandon Blank

Member since: 02/02/2017

675 Reputation

                                      5 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 17-5, Blackwell Spring 2017                        

                                                  Member of USF Tampa, Team 17-5, Blackwell Spring 2017 



                    USFT-BLACKWELL-S17S17G5                     


                                            3 Members                     


                                            12 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team