Difficulty
Easy
Steps
4
Time Required
1 minute
Sections
2
- Rear panel
- 2 steps
- Battery
- 2 steps
Flags
0
BackNABI XD
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear panel
- Use the plastic opening tool at the top left corner seam, then pry the corner apart.
Use the plastic opening tool at the top left corner seam, then pry the corner apart.
1024
Step 2
- Next slide the plastic opening tool across the sides of the Nabi. It will slowly open.
- There are small plastic clips that need to be release. Gently apply outwards pressure until the clips give.
- Go around the NABI XD and separate the rear panel from the device.
Next slide the plastic opening tool across the sides of the Nabi. It will slowly open.
There are small plastic clips that need to be release. Gently apply outwards pressure until the clips give.
Go around the NABI XD and separate the rear panel from the device.
Step 3
Battery
- Place your fingernails on both sides of the connector and pull it straight back away from the holder.
Place your fingernails on both sides of the connector and pull it straight back away from the holder.
Step 4
- Battery is glued to the base, lift carefully.
- To remove battery, lift the battery up from the motherboard.
Battery is glued to the base, lift carefully.
To remove battery, lift the battery up from the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Marissa Schiereck
Member since: 09/15/2016
638 Reputation
6 Guides authored
Badges:
13
+10 more badges
Team
USF Tampa, Team 17-2, Blackwell Fall 2016
Member of USF Tampa, Team 17-2, Blackwell Fall 2016
USFT-BLACKWELL-F16S17G2
3 Members
12 Guides authored
Dave - Oct 19, 2017
Reply
Where can you get the battery?