Difficulty

Moderate

Steps

9

Time Required

Suggest a time??

Sections

2

  • Rear Case
  • 4 steps
  • Motherboard
  • 5 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackNabi Jr

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Rear Case
  • Remove the red rubber case from the device. This should come off with ease.

Remove the red rubber case from the device. This should come off with ease.

1024

Step 2

  • Turn the device so the screen is facing away from you.
  • Using a philips head, size #00, screwdriver, remove the screws in each corner of the plastic casing.(total of 4 screws)

Turn the device so the screen is facing away from you.

Using a philips head, size #00, screwdriver, remove the screws in each corner of the plastic casing.(total of 4 screws)

Step 3

  • Remove the device casing using a small plastic pry bar.
  • This might take a little bit of force to accomplish, don’t be afraid to go at it with a little gusto.

Remove the device casing using a small plastic pry bar.

This might take a little bit of force to accomplish, don’t be afraid to go at it with a little gusto.

Step 4

  • After loosening the back cover, remove it from the device so you can get at the innards.

After loosening the back cover, remove it from the device so you can get at the innards.

Step 5

              Motherboard
  • Use the Philips #00 screwdriver to remove the 5 screws from the motherboard

Use the Philips #00 screwdriver to remove the 5 screws from the motherboard

Step 6

  • De-solder the grey wire from motherboard

De-solder the grey wire from motherboard

Step 7

  • Use tweezers to peel off all yellow tape from the motherboard
  • Yellow tape is used in all locations where there is ribbon cable present.

Use tweezers to peel off all yellow tape from the motherboard

Yellow tape is used in all locations where there is ribbon cable present.

Step 8

  • Remove all three ribbon cables from the motherboard by lifting up the locking tabs.
  • Pull black locking tabs up in opposite direction of ribbon cable to remove.
  • Use tweezers to pull the ribbon cable out of the locking tab’s slot

Remove all three ribbon cables from the motherboard by lifting up the locking tabs.

Pull black locking tabs up in opposite direction of ribbon cable to remove.

Use tweezers to pull the ribbon cable out of the locking tab’s slot

Step 9

  • Lift motherboard to separate it the from the case shell.

Lift motherboard to separate it the from the case shell.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Kaila Joy

Member since: 03/24/2015

86 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       UMass Dartmouth, Team 4-3, Vijaybhaskar Spring 2015                        

                                                  Member of UMass Dartmouth, Team 4-3, Vijaybhaskar Spring 2015 



                    UMASSD-VIJAYBHASKAR-S15S4G3                     


                                            3 Members                     


                                            12 Guides authored