Difficulty
Moderate
Steps
6
Time Required
Suggest a time??
Sections
2
- Rear Case
- 4 steps
- Camera
- 2 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackNabi Jr
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Rear Case
- Remove the red rubber case from the device. This should come off with ease.
Remove the red rubber case from the device. This should come off with ease.
1024
Step 2
- Turn the device so the screen is facing away from you.
- Using a philips head, size #00, screwdriver, remove the screws in each corner of the plastic casing.(total of 4 screws)
Turn the device so the screen is facing away from you.
Using a philips head, size #00, screwdriver, remove the screws in each corner of the plastic casing.(total of 4 screws)
Step 3
- Remove the device casing using a small plastic pry bar.
- This might take a little bit of force to accomplish, don’t be afraid to go at it with a little gusto.
Remove the device casing using a small plastic pry bar.
This might take a little bit of force to accomplish, don’t be afraid to go at it with a little gusto.
Step 4
- After loosening the back cover, remove it from the device so you can get at the innards.
After loosening the back cover, remove it from the device so you can get at the innards.
Step 5
Camera
- Using tweezers remove tape that connects the board to the camera’s ribbon cable.
- The ribbon cable is inserted into a slot on the board.
- Lift the slot’s locking tab up to easily remove the ribbon cable from the board.
- May require force
Using tweezers remove tape that connects the board to the camera’s ribbon cable.
The ribbon cable is inserted into a slot on the board.
Lift the slot’s locking tab up to easily remove the ribbon cable from the board.
May require force
Step 6
- Place the new camera piece in place of the old and plug its ribbon cable back into the respective slot on the board.
- Make sure the locking tab on the slot is in its up position before inserting tape.
- Once the tape is inserted press the locking tab back to its down position to securely fasten the ribbon cable.
Place the new camera piece in place of the old and plug its ribbon cable back into the respective slot on the board.
Make sure the locking tab on the slot is in its up position before inserting tape.
Once the tape is inserted press the locking tab back to its down position to securely fasten the ribbon cable.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Kaila Joy
Member since: 03/24/2015
86 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
UMass Dartmouth, Team 4-3, Vijaybhaskar Spring 2015
Member of UMass Dartmouth, Team 4-3, Vijaybhaskar Spring 2015
UMASSD-VIJAYBHASKAR-S15S4G3
3 Members
12 Guides authored