Difficulty
Easy
Steps
6
Time Required
5 minutes
Sections
2
- Nabi 2S Disassembly
- 4 steps
- Camera
- 2 steps
Flags
0
BackNabi 2S
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Nabi 2S Disassembly
- Remove the red rubber case from the device.
Remove the red rubber case from the device.
1024
Step 2
- Make sure the screen is facing away from you and the back cover is facing you.
- Using a Phillips #0 Screwdriver, unscrew the 3mm screws counter-clockwise in each corner of the plastic back cover. It will be a total of four screws. The smaller case on the back cover is attached to the main cover so it will not need to be removed.
Make sure the screen is facing away from you and the back cover is facing you.
Using a Phillips #0 Screwdriver, unscrew the 3mm screws counter-clockwise in each corner of the plastic back cover. It will be a total of four screws. The smaller case on the back cover is attached to the main cover so it will not need to be removed.
Step 3
- Using the plastic opening tool, remove the case.
- Removing the case will take a bit of effort and force. We recommend using two hands and if possible another person to help. It will require some gusto.
- It is helpful to pry at the corners first to loosen the case.
Using the plastic opening tool, remove the case.
Removing the case will take a bit of effort and force. We recommend using two hands and if possible another person to help. It will require some gusto.
It is helpful to pry at the corners first to loosen the case.
Step 4
- After the back case is loosened, remove it from the device to change or access the battery.
After the back case is loosened, remove it from the device to change or access the battery.
Step 5
Camera
- Unscrew the circuit board from the motherboard by using a Phillips #0 screwdriver to unscrew the ten 4mm screws in a counter-clockwise rotation.
Unscrew the circuit board from the motherboard by using a Phillips #0 screwdriver to unscrew the ten 4mm screws in a counter-clockwise rotation.
Step 6
- The camera is attached to the circuit board and then tucked underneath. Gently grip the part attached to the circuit board and pull it up and away from the circuit.
- Gently slide the camera out from underneath the circuit board.
- The camera is stuck to the device with adhesive tape so do not rapidly remove it.
The camera is attached to the circuit board and then tucked underneath. Gently grip the part attached to the circuit board and pull it up and away from the circuit.
Gently slide the camera out from underneath the circuit board.
The camera is stuck to the device with adhesive tape so do not rapidly remove it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Molly Scott
Member since: 03/07/2016
263 Reputation
1 Guide authored
Badges:
11
+8 more badges
Team
Marist, Team 1-4, Laflen Spring 2016
Member of Marist, Team 1-4, Laflen Spring 2016
MARS-LAFLEN-S16S1G4
2 Members
10 Guides authored