Difficulty
Easy
Steps
5
Time Required
10 - 15 minutes
Sections
2
- Nabi 2 Back Cover Removal
- 3 steps
- Screen
- 2 steps
Flags
1
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
BackNabi 2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
This guide will walk you through the steps of replacing a cracked or otherwise non functioning screen on a Nabi 2. As the screen is glued to the front assembly, we recommend replacing the entire display assembly.
Be sure to use caution when releasing the clips that secure the display ribbon cables. Use a plastic spudger and push directly out, do not pry up on the clips, they will break.
What you need
Step 1
Nabi 2 Back Cover Removal
- Remove the rubber bumper from the tablet.
Remove the rubber bumper from the tablet.
1024
Step 2
- With a PH00 screwdriver, remove the four outermost screws from the back of the tablet.
With a PH00 screwdriver, remove the four outermost screws from the back of the tablet.
Step 3
- Carefully, insert a plastic opening tool into the seam of the device and begin gently prying the two plastic pieces apart.
- Work the tool all the way around the device. Small plastic clips should release. If they do not, gently apply outwards pressure until the clips give.
- Do not force the clips open, as they are fairly easy to break
Carefully, insert a plastic opening tool into the seam of the device and begin gently prying the two plastic pieces apart.
Work the tool all the way around the device. Small plastic clips should release. If they do not, gently apply outwards pressure until the clips give.
Do not force the clips open, as they are fairly easy to break
Step 4
Screen
- Lay the tablet down flat and remove the yellow tape from the ZIF connector on each side
Lay the tablet down flat and remove the yellow tape from the ZIF connector on each side
Step 5
- Using a spudger, slide the brown tab forward on each side of the connector
- Slide until the connector is completely loose, then separate the screen from the bottom half of the tablet
- If the screen is not working correctly, you will need to replace the entire display assembly
Using a spudger, slide the brown tab forward on each side of the connector
Slide until the connector is completely loose, then separate the screen from the bottom half of the tablet
If the screen is not working correctly, you will need to replace the entire display assembly
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
6 other people completed this guide.
Author
with 3 other contributors
Michelle
Member since: 02/09/2016
851 Reputation
4 Guides authored
Badges:
18
+15 more badges
Team
USF Tampa, Team 4-3, Lacy Spring 2016
Member of USF Tampa, Team 4-3, Lacy Spring 2016
USFT-LACY-S16S4G3
4 Members
14 Guides authored
myjamro - Jul 23, 2016
Reply
Simple steps but very practical
Brent Huff - Oct 6, 2016
Reply
Is the LCD glued to the front glass/digitizer?
Sharon Thrash - May 15, 2017
Reply
It Worked Thank U So Much!!!