N Strike Nite Finder Ex 3 Leaf Spring Switch Replacement Guide Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 20 minutes

Sections

Leaf Spring Switch
4 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

BackNerf N-Strike Nite Finder EX-3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Leaf Spring Switch

Place the blaster upside down on the table, and remove the screw in the bottom of the handle.
Remove the battery door and take the batteries out.

Place the blaster upside down on the table, and remove the screw in the bottom of the handle.

Remove the battery door and take the batteries out.

1024

Step 2

Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.
Lift the side of the blaster off exposing its internal parts.

Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.

Lift the side of the blaster off exposing its internal parts.

Step 3

Work the trigger to ensure the problem is the switch not making a proper connection.
Remove the retaining phillips head 10.2 mm screw below the switch.

Work the trigger to ensure the problem is the switch not making a proper connection.

Remove the retaining phillips head 10.2 mm screw below the switch.

Step 4

Use a hot soldering iron to melt the solder of the two wires at the rear of the switch. Take note that the red wire leads from the top of the switch.

Use a hot soldering iron to melt the solder of the two wires at the rear of the switch. Take note that the red wire leads from the top of the switch.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors

                    Jeffrey Sargeant

Member since: 02/24/2014

345 Reputation

                                      1 Guide authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Michigan Tech, Team 5-8, Lauer Spring 2014                        

                                                  Member of Michigan Tech, Team 5-8, Lauer Spring 2014 



                    MTU-LAUER-S14S5G8                     


                                            3 Members                     


                                            13 Guides authored

Slice and Dice#

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Slice and Dice

Introduction

What you need

Team