Difficulty
Moderate
Steps
5
Time Required
10 minutes
Sections
2
- External Casing
- 3 steps
- Camera
- 2 steps
Flags
0
BackMunchkinz
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Opening Device
- Insert spudger into the USB Micro slot and pry the case apart.
- Be careful not to go too deep and bend the prong inside the Micro USB port.
Insert spudger into the USB Micro slot and pry the case apart.
Be careful not to go too deep and bend the prong inside the Micro USB port.
1024
Step 2
Pry Device Apart
- Slide the wide plastic opening tool across the seem, separating it if you can’t pry the device open using just the spudger.
- Gently separate the case so none of the cords inside are disconnected
Slide the wide plastic opening tool across the seem, separating it if you can’t pry the device open using just the spudger.
Gently separate the case so none of the cords inside are disconnected
Step 3
Separated Device
- After prying the device apart, it should look like this.
After prying the device apart, it should look like this.
Step 4
Pry Camera
- Use the slim plastic opening tool to pry the camera from its initial position.
Use the slim plastic opening tool to pry the camera from its initial position.
Step 5
Disconnect Ribbon
- Use the precision tweezers to gently disconnect the camera ribbon that is connected to the motherboard.
Use the precision tweezers to gently disconnect the camera ribbon that is connected to the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
David Wood
Member since: 02/05/2015
440 Reputation
4 Guides authored
Badges:
6
+3 more badges
Team
UW Tacoma, Team 3-6, Rose Winter 2015
Member of UW Tacoma, Team 3-6, Rose Winter 2015
UWT-ROSE-W15S3G6
3 Members
14 Guides authored
