Difficulty
Moderate
Steps
5
Time Required
5 - 10 minutes
Sections
2
- External Casing
- 3 steps
- Battery
- 2 steps
Flags
0
BackMunchkinz
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Opening Device
- Insert spudger into the USB Micro slot and pry the case apart.
- Be careful not to go too deep and bend the prong inside the Micro USB port.
Insert spudger into the USB Micro slot and pry the case apart.
Be careful not to go too deep and bend the prong inside the Micro USB port.
1024
Step 2
Pry Device Apart
- Slide the wide plastic opening tool across the seem, separating it if you can’t pry the device open using just the spudger.
- Gently separate the case so none of the cords inside are disconnected
Slide the wide plastic opening tool across the seem, separating it if you can’t pry the device open using just the spudger.
Gently separate the case so none of the cords inside are disconnected
Step 3
Separated Device
- After prying the device apart, it should look like this.
After prying the device apart, it should look like this.
Step 4
Removing battery
- Use the wide plastic opening tool to slowly pry each side of the battery up.
- Be careful not to bend the battery too much.
Use the wide plastic opening tool to slowly pry each side of the battery up.
Be careful not to bend the battery too much.
Step 5
Remove battery completely
- Use the Soldering Iron to disconnect the each cable.
Use the Soldering Iron to disconnect the each cable.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Hee Jin Cho
Member since: 01/14/2015
113 Reputation
1 Guide authored
Badges:
6
+3 more badges
Team
UW Tacoma, Team 3-6, Rose Winter 2015
Member of UW Tacoma, Team 3-6, Rose Winter 2015
UWT-ROSE-W15S3G6
3 Members
14 Guides authored