Difficulty
Moderate
Steps
10
Time Required
30 minutes
Sections
3
- Battery
- 3 steps
- Hard Drive
- 3 steps
- Keyboard
- 4 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackMSI GT70 MS-1763
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
S1N-3EUS204, V139922AK1
What you need
Step 1
Battery
- Power off the laptop and turn it over.
Power off the laptop and turn it over.
1024
Step 2
- Release the safety latches that hold the battery in place. The left latch will stay moved up, while the right side is spring activated and will have to be held.
Release the safety latches that hold the battery in place. The left latch will stay moved up, while the right side is spring activated and will have to be held.
Step 3
- While holding up the left latch, use a Jimmy and slide the old battery out of its compartment.
While holding up the left latch, use a Jimmy and slide the old battery out of its compartment.
Step 4
Hard Drive
- Remove all twelve 4 mm Phillips #0 screws from the back of the laptop.
- Remove the back cover.
Remove all twelve 4 mm Phillips #0 screws from the back of the laptop.
Remove the back cover.
Step 5
- Remove the rubber spacer holding the hard drive secure.
Remove the rubber spacer holding the hard drive secure.
Step 6
- Slide the hard drive to the left, removing it from its bay.
Slide the hard drive to the left, removing it from its bay.
Step 7
Keyboard
- Using a Jimmy, remove the outer cover around the keyboard.
- Remove the ribbon cable from the ZIF connector on the underside of the top cover.
Using a Jimmy, remove the outer cover around the keyboard.
Remove the ribbon cable from the ZIF connector on the underside of the top cover.
Step 8
- Using a Phillips #0 screwdriver, remove the five 3 mm screws at the top of the keyboard.
Using a Phillips #0 screwdriver, remove the five 3 mm screws at the top of the keyboard.
Step 9
- Flip the keyboard back and disconnect the keyboard cable.
Flip the keyboard back and disconnect the keyboard cable.
Step 10
- Flip the laptop over and disconnect the data cable from the ZIF connector on the bottom right.
- You can now turn the laptop back over and remove the keyboard.
Flip the laptop over and disconnect the data cable from the ZIF connector on the bottom right.
You can now turn the laptop back over and remove the keyboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 6 other contributors
Bhrett Farrar
Member since: 08/22/2019
109 Reputation
1 Guide authored
Badges:
4
+1 more badge
Team
South Arkansas Community College, Team S1-G2, Mitchell Fall 2019
Member of South Arkansas Community College, Team S1-G2, Mitchell Fall 2019
SACC-MITCHELL-F19S1G2
3 Members
6 Guides authored
garegin - May 16, 2022
Reply
Mine is the Cyberbuypower rebadge of this model. And you only need to remove the two keyboards screws on the bottom. And then the top button board (called outer cover here)
Even here I don’t see why you have to remove all those screws.