Difficulty
Moderate
Steps
9
Time Required
1 - 2 minutes
Sections
3
- Back Panel
- 3 steps
- Battery
- 3 steps
- Speaker
- 3 steps
Flags
0
BackMSI GS60 Ghost Pro 4K Gold Edition
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Place this device back panel facing up.
Place this device back panel facing up.
1024
Step 2
- Using the screwdriver, unscrew the highlighted 1.2mm Phillips head #0 screws which secure the back panel into place.
Using the screwdriver, unscrew the highlighted 1.2mm Phillips head #0 screws which secure the back panel into place.
Step 3
- Using the plastic opening tools, separate the back panel from the rest of the device.
- Do this by firmly pressing the head of the tool into the space between the back panel, and the rest of the device.
Using the plastic opening tools, separate the back panel from the rest of the device.
Do this by firmly pressing the head of the tool into the space between the back panel, and the rest of the device.
Step 4
Battery
- Pull the back panel off.
Pull the back panel off.
Step 5
- Notice the L-shaped battery in the lower right corner of the opened laptop.
- Disconnect the battery from the slot it is connected to. You’ll need to push on the sides of the clip and pull.
Notice the L-shaped battery in the lower right corner of the opened laptop.
Disconnect the battery from the slot it is connected to. You’ll need to push on the sides of the clip and pull.
Step 6
- Lift up the battery with your fingers and remove it from the laptop.
- Place the battery away from the laptop in a safe spot and insert your new battery by hooking it up to the slot you previously disconnected the old battery from.
Lift up the battery with your fingers and remove it from the laptop.
Place the battery away from the laptop in a safe spot and insert your new battery by hooking it up to the slot you previously disconnected the old battery from.
Step 7
Speaker
- Disconnect the wires connnecting the speaker to the motherboard by grasping the portion of the cable covered in black shielding, and carefully pulling it horizontally away from the port it is connected to.
- Be careful not to pull the cable too hard and bend the port on connecting the speakers to the motherboard.
Disconnect the wires connnecting the speaker to the motherboard by grasping the portion of the cable covered in black shielding, and carefully pulling it horizontally away from the port it is connected to.
Be careful not to pull the cable too hard and bend the port on connecting the speakers to the motherboard.
Step 8
- Use the screwdriver to unscrew the 4 1.5mm Phillips #0 screws connecting the speakers to the frame of the device.
- There are 2 individual speaker modules, with 2 screws each.
Use the screwdriver to unscrew the 4 1.5mm Phillips #0 screws connecting the speakers to the frame of the device.
There are 2 individual speaker modules, with 2 screws each.
Step 9
- Carefully pull both the left and right speaker modules out of the computer.
Carefully pull both the left and right speaker modules out of the computer.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
nonEdward666
Member since: 10/18/2017
322 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
UMass Dartmouth, Team S2-G2, Julie Fall 2017
Member of UMass Dartmouth, Team S2-G2, Julie Fall 2017
UMASSD-JULIE-F17S2G2
4 Members
7 Guides authored
