Difficulty
Moderate
Steps
6
Time Required
6 minutes
Sections
2
- Back Panel
- 3 steps
- Fan
- 3 steps
Flags
0
BackMSI GP60 2PE Leopard
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Flip the device over so the back is facing up.
Flip the device over so the back is facing up.
1024
Step 2
- Remove the four 5mm screws from the back of the device using a Phillips #00 screwdriver.
- There is a screw located under the battery; lift the battery up to access it.
Remove the four 5mm screws from the back of the device using a Phillips #00 screwdriver.
There is a screw located under the battery; lift the battery up to access it.
Step 3
- Once all four screws are removed, lift the back off.
Once all four screws are removed, lift the back off.
Step 4
Fan
- Remove the three 5 mm screws from the fan with a Phillips #00 screwdriver.
Remove the three 5 mm screws from the fan with a Phillips #00 screwdriver.
Step 5
- Pull the wire on the bottom left of the fan out of the socket.
- Pull the wire gently; pulling too hard could damage the wire.
Pull the wire on the bottom left of the fan out of the socket.
Pull the wire gently; pulling too hard could damage the wire.
Step 6
- Remove the fan.
Remove the fan.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Zoey Calcagno
Member since: 10/04/2018
672 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
Linn Benton Community College, Team S1-G4, Karnes Fall 2018
Member of Linn Benton Community College, Team S1-G4, Karnes Fall 2018
LBCC-KARNES-F18S1G4
4 Members
6 Guides authored