Difficulty

Moderate

Steps

6

Time Required

                          30 minutes

Sections

2

  • Battery
  • 3 steps
  • Screen
  • 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackMSI GE62 Apache Pro 004

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery
  • Start with the bottom of the laptop facing up.

Start with the bottom of the laptop facing up.

1024

Step 2

  • Remove the 15 screws from the bottom of the laptop with a PH1 screwdriver.
  • Remove the bottom plate
  • Keep track of all the screws and which slot they came from, as they slightly differ. We recommend this system: lay out on a piece of paper and pretending the paper is the device. Place the screws on the paper approximately where they would go

Remove the 15 screws from the bottom of the laptop with a PH1 screwdriver.

Remove the bottom plate

Keep track of all the screws and which slot they came from, as they slightly differ. We recommend this system: lay out on a piece of paper and pretending the paper is the device. Place the screws on the paper approximately where they would go

Step 3

  • Remove the screw holding down the battery with a PH1 screwdriver.
  • Pull out the battery.

Remove the screw holding down the battery with a PH1 screwdriver.

Pull out the battery.

Step 4

              Screen
  • Open the laptop up as if you were going to use it.
  • Wedge a spudger in between the screen bezel and work it around to separate it.

Open the laptop up as if you were going to use it.

Wedge a spudger in between the screen bezel and work it around to separate it.

Step 5

  • Remove the screws holding in the screen at the corners with a PH1 screwdriver.
  • Be very careful as the screen may tilt forward so make sure your hand is right is on the screen when the screw comes off.

Remove the screws holding in the screen at the corners with a PH1 screwdriver.

Be very careful as the screen may tilt forward so make sure your hand is right is on the screen when the screw comes off.

Step 6

  • Remove the bezel from the screen.
  • Remove the two screws located at the bottom of the screen using the PH1 screwdriver.

Remove the bezel from the screen.

Remove the two screws located at the bottom of the screen using the PH1 screwdriver.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Samer Soukieh

Member since: 02/19/2018

209 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       USF Tampa, Team S15-G5, Boczar Spring 2018                        

                                                  Member of USF Tampa, Team S15-G5, Boczar Spring 2018 



                    USFT-BOCZAR-S18S15G5                     


                                            4 Members                     


                                            5 Guides authored