Difficulty
Easy
Steps
8
Time Required
15 - 30 minutes
Sections
2
- Casing
- 5 steps
- LCD Screen
- 3 steps
Flags
0
BackMoultrie I45 GameSpy
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Casing
- Using a Philips head screwdriver, remove the eight 6mm screws located at the bottom of the device.
Using a Philips head screwdriver, remove the eight 6mm screws located at the bottom of the device.
1024
Step 2
- Remove the butterfly nut from the lid arm.
Remove the butterfly nut from the lid arm.
Step 3
- Remove the lid-covering.
Remove the lid-covering.
Step 4
- Using a Phillips head screwdriver, remove the six 4mm screws from the face of the camera.
Using a Phillips head screwdriver, remove the six 4mm screws from the face of the camera.
Step 5
- Gently separate the two halves of the case.
- The two halves are connected by a wire. Pulling too roughly can damage the wires and cause the camera to stop functioning.
Gently separate the two halves of the case.
The two halves are connected by a wire. Pulling too roughly can damage the wires and cause the camera to stop functioning.
Step 6
LCD Screen
- Using a Philips head screwdriver, remove the 12, 3mm screws from the board.
Using a Philips head screwdriver, remove the 12, 3mm screws from the board.
Step 7
- Gently remove the circuit board from the face of the camera
Gently remove the circuit board from the face of the camera
Step 8
- Remove the LCD screen.
Remove the LCD screen.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Sean Hill
Member since: 01/29/2015
434 Reputation
4 Guides authored
Badges:
5
+2 more badges
Team
UW Tacoma, Team 3-7, Rose Winter 2015
Member of UW Tacoma, Team 3-7, Rose Winter 2015
UWT-ROSE-W15S3G7
3 Members
4 Guides authored