Difficulty

Easy

Steps

4

Time Required

                          5 - 10 minutes

Sections

2

  • Back Cover Disassembly
  • 3 steps
  • Speakers
  • 1 step

Flags

1

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackMotorola Xoom Wi-Fi

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover Disassembly
  • There are two 6.6 mm screws that hold ports into place as well as the back panel. Remove these with a T5 Torx screwdriver.

There are two 6.6 mm screws that hold ports into place as well as the back panel. Remove these with a T5 Torx screwdriver.

1024

Step 2

  • Apply light pressure with hand and slide the back plate till it stops in this position.
  • There is a flex clip on both sides that need to be pushed down in order for the plate to slide off completely. Use a plastic opening tool to release the flex clips. They are located under the back cover near the sides.
  • As soon as the clips are released the back should slide off.

Apply light pressure with hand and slide the back plate till it stops in this position.

There is a flex clip on both sides that need to be pushed down in order for the plate to slide off completely. Use a plastic opening tool to release the flex clips. They are located under the back cover near the sides.

As soon as the clips are released the back should slide off.

Step 3

  • Remove last two 4.2 mm screws from the remaining back piece with a T5 Torx screwdriver.
  • Once both screws are taken out, lift the rest of the backing out of the way.

Remove last two 4.2 mm screws from the remaining back piece with a T5 Torx screwdriver.

Once both screws are taken out, lift the rest of the backing out of the way.

Step 4

              Speakers
  • Use a plastic opening tool to pop out the speaker. Make sure to carefully pull off the wire as well.
  • Replace speaker if necessary.

Use a plastic opening tool to pop out the speaker. Make sure to carefully pull off the wire as well.

Replace speaker if necessary.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Mallika

Member since: 04/20/2014

464 Reputation

                                      2 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges

Team

                       Cal Poly, Team 3-39, Maness Spring 2014                        

                                                  Member of Cal Poly, Team 3-39, Maness Spring 2014 



                    CPSU-MANESS-S14S3G39                     


                                            4 Members                     


                                            16 Guides authored