Difficulty

Moderate

Steps

9

Time Required

                          5 minutes

Sections

5

  • Battery
  • 2 steps
  • Back Plate
  • 3 steps
  • Motherboard
  • 2 steps
  • Keypad Sensor
  • 1 step
  • Keypad
  • 1 step

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

  • BackMotorola V60i

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Flip the phone over so the back cover is facing up.
  • Using either a finger or a spudger, press the button located near the top of the phone by the antenna.

Flip the phone over so the back cover is facing up.

Using either a finger or a spudger, press the button located near the top of the phone by the antenna.

1024

Step 2

  • Pry up the back plate from the phone.
  • Push the button near the bottom of the battery using either your finger or the spudger to release the battery.

Pry up the back plate from the phone.

Push the button near the bottom of the battery using either your finger or the spudger to release the battery.

Step 3

              Back Plate
  • Using a T6 Torx screwdriver, remove the four screws from the back of the phone.

Using a T6 Torx screwdriver, remove the four screws from the back of the phone.

Step 4

  • Simultaneously press the highlighted buttons on both sides of phone.

Simultaneously press the highlighted buttons on both sides of phone.

Step 5

  • Separate the back plate from the rest of phone.
  • Do not pull the wire connecting the front and back plates.

Separate the back plate from the rest of phone.

Do not pull the wire connecting the front and back plates.

Step 6

              Motherboard
  • Gently lift logic board from back plate.

Gently lift logic board from back plate.

Step 7

  • Place logic board on front cover.
  • Unsnap orange wire that connects the logic board to keypad sensor to allow the logic board to move freely.

Place logic board on front cover.

Unsnap orange wire that connects the logic board to keypad sensor to allow the logic board to move freely.

Step 8

              Keypad Sensor
  • Once logic board is removed lift the green keypad sensor for the front plate.

Once logic board is removed lift the green keypad sensor for the front plate.

Step 9

              Keypad
  • To replace keypad buttons, lift off white tray containing buttons.

To replace keypad buttons, lift off white tray containing buttons.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 


                    Elizabeth OBrien

Member since: 04/26/2010

43 Reputation

                                      7 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 30-40, Garner Spring 2010                        

                                                  Member of Cal Poly, Team 30-40, Garner Spring 2010 



                    CPSU-GARNER-S10S30G40                     


                                            4 Members                     


                                            14 Guides authored