Difficulty
Moderate
Steps
10
Time Required
20 - 30 minutes
Sections
4
- Battery
- 2 steps
- Circuit Board
- 5 steps
- Keypad
- 1 step
- Keypad Key
- 2 steps
Flags
0
BackMotorola V551
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Press down on the chrome button on the bottom of the chassis. Simultaneously slide the back cover down, away from the phone.
Press down on the chrome button on the bottom of the chassis. Simultaneously slide the back cover down, away from the phone.
1024
Step 2
- Lever the battery out by pressing upwards on the bottom corners of the battery.
Lever the battery out by pressing upwards on the bottom corners of the battery.
Step 3
Circuit Board
- Remove the rubber screw covers using a plastic spudger.
- Use a T6 Torx screwdriver to remove the screws underneath the rubber screw covers.
Remove the rubber screw covers using a plastic spudger.
Use a T6 Torx screwdriver to remove the screws underneath the rubber screw covers.
Step 4
- Unscrew the antenna.
Unscrew the antenna.
Step 5
- Gently release the two latches using an opening tool.
- The plastic latches are very fragile. Don’t use excessive force or they might break.
- Pry off the back panel by wedging an opening tool into the crevice between the back panel and the circuit board.
- Lift the back panel off of the phone.
Gently release the two latches using an opening tool.
The plastic latches are very fragile. Don’t use excessive force or they might break.
Pry off the back panel by wedging an opening tool into the crevice between the back panel and the circuit board.
Lift the back panel off of the phone.
Step 6
- Loosen the copper circuit board connection with an opening tool.
- Gently lift the copper connection.
Loosen the copper circuit board connection with an opening tool.
Gently lift the copper connection.
Step 7
- Lift up and pull out the pressure pad from under the buttons on the side of the chassis.
- Gently lift the motherboard off of the front panel.
Lift up and pull out the pressure pad from under the buttons on the side of the chassis.
Gently lift the motherboard off of the front panel.
Step 8
Keypad
- Push both side keys in so they are not sticking out of the phone.
- Remove the keypad.
Push both side keys in so they are not sticking out of the phone.
Remove the keypad.
Step 9
Keypad Key
- Gently squeeze the bottle of super glue so that only a small amount (about 1/3 pinky width) is a applied to the back side of the key.
- Be careful while applying the super glue as it can be quite strong.
Gently squeeze the bottle of super glue so that only a small amount (about 1/3 pinky width) is a applied to the back side of the key.
Be careful while applying the super glue as it can be quite strong.
Step 10
- Carefully place key onto the key pad so that it will be properly oriented and in line with the other keys.
Carefully place key onto the key pad so that it will be properly oriented and in line with the other keys.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 6 other contributors
gregatron
Member since: 10/29/2009
105 Reputation
6 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team 6-6, Maness Fall 2009
Member of Cal Poly, Team 6-6, Maness Fall 2009
CPSU-MANESS-F09S6G6
4 Members
12 Guides authored