Difficulty

Moderate

Steps

7

Time Required

                          15 minutes

Sections

2

  • Battery
  • 2 steps
  • Circuit Board
  • 5 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackMotorola V551

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Press down on the chrome button on the bottom of the chassis. Simultaneously slide the back cover down, away from the phone.

Press down on the chrome button on the bottom of the chassis. Simultaneously slide the back cover down, away from the phone.

1024

Step 2

  • Lever the battery out by pressing upwards on the bottom corners of the battery.

Lever the battery out by pressing upwards on the bottom corners of the battery.

Step 3

              Circuit Board
  • Remove the rubber screw covers using a plastic spudger.
  • Use a T6 Torx screwdriver to remove the screws underneath the rubber screw covers.

Remove the rubber screw covers using a plastic spudger.

Use a T6 Torx screwdriver to remove the screws underneath the rubber screw covers.

Step 4

  • Unscrew the antenna.

Unscrew the antenna.

Step 5

  • Gently release the two latches using an opening tool.
  • The plastic latches are very fragile. Don’t use excessive force or they might break.
  • Pry off the back panel by wedging an opening tool into the crevice between the back panel and the circuit board.
  • Lift the back panel off of the phone.

Gently release the two latches using an opening tool.

The plastic latches are very fragile. Don’t use excessive force or they might break.

Pry off the back panel by wedging an opening tool into the crevice between the back panel and the circuit board.

Lift the back panel off of the phone.

Step 6

  • Loosen the copper circuit board connection with an opening tool.
  • Gently lift the copper connection.

Loosen the copper circuit board connection with an opening tool.

Gently lift the copper connection.

Step 7

  • Lift up and pull out the pressure pad from under the buttons on the side of the chassis.
  • Gently lift the motherboard off of the front panel.

Lift up and pull out the pressure pad from under the buttons on the side of the chassis.

Gently lift the motherboard off of the front panel.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 7 other contributors 


                    gregatron

Member since: 10/29/2009

105 Reputation

                                      6 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 6-6, Maness Fall 2009                        

                                                  Member of Cal Poly, Team 6-6, Maness Fall 2009 



                    CPSU-MANESS-F09S6G6                     


                                            4 Members                     


                                            12 Guides authored