Difficulty

Moderate

Steps

8

Time Required

Suggest a time??

Sections

3

  • Battery
  • 2 steps
  • SIM Card
  • 1 step
  • Antenna
  • 5 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackMotorola Razr V3m

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery
  • Press the release button located on the upper edge of the battery cover. At the same time, lift the battery cover away from the phone.

Press the release button located on the upper edge of the battery cover. At the same time, lift the battery cover away from the phone.

1024

Step 2

  • Push the top edge of the battery and lift away from the phone.

Push the top edge of the battery and lift away from the phone.

Step 3

              SIM Card
  • Gently pull the SIM Card toward the top of the phone with your finger.

Gently pull the SIM Card toward the top of the phone with your finger.

Step 4

              Antenna
  • Remove the two screws from the back panel with a T6 screwdriver.

Remove the two screws from the back panel with a T6 screwdriver.

Step 5

  • Carefully use a plastic opening tool to pry back panel open.
  • The back panel is attached to the phone with a copper ribbon that acts as a hinge.
  • Carefully open out the back panel to the side of the phone corresponding with the hinge.
  • Do not pull back away from phone. It may damage the copper ribbon.

Carefully use a plastic opening tool to pry back panel open.

The back panel is attached to the phone with a copper ribbon that acts as a hinge.

Carefully open out the back panel to the side of the phone corresponding with the hinge.

Do not pull back away from phone. It may damage the copper ribbon.

Step 6

  • Use tweezers to disconnect the copper ribbon from the inside of the back panel.

Use tweezers to disconnect the copper ribbon from the inside of the back panel.

Step 7

  • Use tweezers to remove the tiny red and blue rubber covers located on the top of the antenna.

Use tweezers to remove the tiny red and blue rubber covers located on the top of the antenna.

Step 8

  • Use a plastic opening tool to pry the edge of the antenna away from back panel.
  • The antenna may be fastened with two grey clips on either side. If this is so, unfasten two plastic clips located on the edge of the antenna.
  • Lift antenna away from back panel.

Use a plastic opening tool to pry the edge of the antenna away from back panel.

The antenna may be fastened with two grey clips on either side. If this is so, unfasten two plastic clips located on the edge of the antenna.

Lift antenna away from back panel.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Daniel Simcock

Member since: 10/24/2015

731 Reputation

                                      6 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       UMass Dartmouth, Team 3-2, Shastany Fall 2015                        

                                                  Member of UMass Dartmouth, Team 3-2, Shastany Fall 2015 



                    UMASSD-SHASTANY-F15S3G2                     


                                            4 Members                     


                                            7 Guides authored