Difficulty
Moderate
Steps
10
Time Required
15 minutes
Sections
2
- Battery (CDMA)
- 2 steps
- Keypad Cover (CDMA)
- 8 steps
Flags
0
BackMotorola Razr V3c
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery (CDMA)
- Press down on the the rear panel release button while simultaneously prying the rear panel straight away from the V3c.
- Lift and remove the rear panel away from the V3c.
Press down on the the rear panel release button while simultaneously prying the rear panel straight away from the V3c.
Lift and remove the rear panel away from the V3c.
1024
Step 2
- Remove the battery by pushing in the top of the battery and lifting it away from the phone.
Remove the battery by pushing in the top of the battery and lifting it away from the phone.
Step 3
Keypad Cover (CDMA)
- Remove the two T6 screws on the back of the phone.
Remove the two T6 screws on the back of the phone.
Step 4
- Use the plastic opening tool to pop the bottom part of the back case out.
- The back case is connected to the phone with a ribbon cable; take care not to pull too hard or violently on the cable.
Use the plastic opening tool to pop the bottom part of the back case out.
The back case is connected to the phone with a ribbon cable; take care not to pull too hard or violently on the cable.
Step 5
- Gently pull back case out and lay it over to the side.
- Now pull up on the cable attaching the back case to the phone body to separate the two parts. Lay the back case aside for now.
Gently pull back case out and lay it over to the side.
Now pull up on the cable attaching the back case to the phone body to separate the two parts. Lay the back case aside for now.
Step 6
- Remove the two T6 screws securing the plastic speaker cover to the phone.
Remove the two T6 screws securing the plastic speaker cover to the phone.
Step 7
- Pull off the lower front casing.
- The metal shield will come off when the lower front casing is removed. Make sure to replace this when reassembling the lower bottom casing.
Pull off the lower front casing.
The metal shield will come off when the lower front casing is removed. Make sure to replace this when reassembling the lower bottom casing.
Step 8
- Pull the silver plastic cover down away from the rest of the phone.
Pull the silver plastic cover down away from the rest of the phone.
Step 9
- Push the metal tabs along the perimeter of the device through towards the keyboard with your fingers.
Push the metal tabs along the perimeter of the device through towards the keyboard with your fingers.
Step 10
- Gently lift up on the keypad with the plastic opening tool while being careful not to bend the thin metal portion lining the keypad.
Gently lift up on the keypad with the plastic opening tool while being careful not to bend the thin metal portion lining the keypad.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 10 other contributors
krisko
Member since: 01/14/2010
95 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team 11-4, Forte Winter 2010
Member of Cal Poly, Team 11-4, Forte Winter 2010
CPSU-FORTE-W10S11G4
3 Members
8 Guides authored