Difficulty

Easy

Steps

7

Time Required

                          5 minutes

Sections

2

  • Battery
  • 2 steps
  • Main Logic Board
  • 5 steps

Flags

1

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

  • BackMotorola W755

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Using your finger, press down on the clip holding the back cover on
  • Pull the back cover off.

Using your finger, press down on the clip holding the back cover on

Pull the back cover off.

1024

Step 2

  • Place thumb and index finger in the spaces on either side of the battery.
  • Pull battery out.

Place thumb and index finger in the spaces on either side of the battery.

Pull battery out.

Step 3

              Main Logic Board
  • Using the T5 Torx-screwdriver, remove the four 5.5 mm screws on the back panel.

Using the T5 Torx-screwdriver, remove the four 5.5 mm screws on the back panel.

Step 4

  • Using a plastic opening tool, carefully peel back the rubber strip located at the bottom of the keypad
  • Remove the two T5 Torx-screws underneath the rubber strip using the T5 Torx-screwdriver

Using a plastic opening tool, carefully peel back the rubber strip located at the bottom of the keypad

Remove the two T5 Torx-screws underneath the rubber strip using the T5 Torx-screwdriver

Step 5

  • Using the flat end of the plastic opening tool, insert it in the gap between the charging port and plastic at the bottom left side of the phone.
  • Slide the opening tool around the phone clockwise until you reach the audio port.
  • Twist the opening tool until the plastic pops off from the body of the phone. This make require a small amount of force.

Using the flat end of the plastic opening tool, insert it in the gap between the charging port and plastic at the bottom left side of the phone.

Slide the opening tool around the phone clockwise until you reach the audio port.

Twist the opening tool until the plastic pops off from the body of the phone. This make require a small amount of force.

Step 6

  • Remove the plastic covering completely from the body of the phone.

Remove the plastic covering completely from the body of the phone.

Step 7

  • Using the plastic opening tool, carefully unclip the cable ribbon from the main logic board. Be sure not to tear it because the flex is very fragile.
  • Remove the main logic board.

Using the plastic opening tool, carefully unclip the cable ribbon from the main logic board. Be sure not to tear it because the flex is very fragile.

Remove the main logic board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    C Miller

Member since: 06/25/2012

56 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 1-3, Regan SU 2012                        

                                                  Member of Cal Poly, Team 1-3, Regan SU 2012 



                    CPSU-REGAN-SU12S1G3                     


                                            2 Members                     


                                            14 Guides authored