Difficulty
Moderate
Steps
6
Time Required
15 - 30 minutes
Sections
2
- Main Logic Board
- 5 steps
- Functional Keypad
- 1 step
Flags
1
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackMotorola W755
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Main Logic Board
- Using the T5 Torx-screwdriver, remove the four 5.5 mm screws on the back panel.
Using the T5 Torx-screwdriver, remove the four 5.5 mm screws on the back panel.
1024
Step 2
- Using a plastic opening tool, carefully peel back the rubber strip located at the bottom of the keypad
- Remove the two T5 Torx-screws underneath the rubber strip using the T5 Torx-screwdriver
Using a plastic opening tool, carefully peel back the rubber strip located at the bottom of the keypad
Remove the two T5 Torx-screws underneath the rubber strip using the T5 Torx-screwdriver
Step 3
- Using the flat end of the plastic opening tool, insert it in the gap between the charging port and plastic at the bottom left side of the phone.
- Slide the opening tool around the phone clockwise until you reach the audio port.
- Twist the opening tool until the plastic pops off from the body of the phone. This make require a small amount of force.
Using the flat end of the plastic opening tool, insert it in the gap between the charging port and plastic at the bottom left side of the phone.
Slide the opening tool around the phone clockwise until you reach the audio port.
Twist the opening tool until the plastic pops off from the body of the phone. This make require a small amount of force.
Step 4
- Remove the plastic covering completely from the body of the phone.
Remove the plastic covering completely from the body of the phone.
Step 5
- Using the plastic opening tool, carefully unclip the cable ribbon from the main logic board. Be sure not to tear it because the flex is very fragile.
- Remove the main logic board.
Using the plastic opening tool, carefully unclip the cable ribbon from the main logic board. Be sure not to tear it because the flex is very fragile.
Remove the main logic board.
Step 6
Functional Keypad
- Lift the plastic cover of the keypad from the top of the main logic board and peel it off.
Lift the plastic cover of the keypad from the top of the main logic board and peel it off.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Roberta Glenn
Member since: 07/11/2012
43 Reputation
4 Guides authored
Badges:
10
+7 more badges
Team
Cal Poly, Team 1-3, Regan SU 2012
Member of Cal Poly, Team 1-3, Regan SU 2012
CPSU-REGAN-SU12S1G3
2 Members
14 Guides authored