Difficulty
Moderate
Steps
9
Time Required
15 - 30 minutes
Sections
3
- Battery
- 2 steps
- Top Panel
- 5 steps
- Camera
- 2 steps
Flags
1
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackMotorola W755
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Using your finger, press down on the clip holding the back cover on
- Pull the back cover off.
Using your finger, press down on the clip holding the back cover on
Pull the back cover off.
1024
Step 2
- Place thumb and index finger in the spaces on either side of the battery.
- Pull battery out.
Place thumb and index finger in the spaces on either side of the battery.
Pull battery out.
Step 3
Top Panel
- Use the plastic opening tool to pull peel back screen cover.
- Gently peel back the screen cover from the speaker slit.
- Using the T6 Torx-screwdriver, remove the four 4.3 mm screws from the top panel.
Use the plastic opening tool to pull peel back screen cover.
Gently peel back the screen cover from the speaker slit.
Using the T6 Torx-screwdriver, remove the four 4.3 mm screws from the top panel.
Step 4
- Using the flat end of the plastic opening tool, insert it underneath the plastic cover on the top right corner.
- Move the opening tool around the phone counter clockwise.
- Pop the plastic cover off by twisting the plastic covering tool.
Using the flat end of the plastic opening tool, insert it underneath the plastic cover on the top right corner.
Move the opening tool around the phone counter clockwise.
Pop the plastic cover off by twisting the plastic covering tool.
Step 5
- Using a flat head screwdriver, insert it between the metal logic board casing and the top portion of the phone
- Move the plastic opening tool around the phone until part of the casting is popped off.
- You will need to pop in the four plastic fasteners individually from the metal casing to remove it
- Be careful not to rip the cable ribbons that are attached to the logic board and casing
Using a flat head screwdriver, insert it between the metal logic board casing and the top portion of the phone
Move the plastic opening tool around the phone until part of the casting is popped off.
You will need to pop in the four plastic fasteners individually from the metal casing to remove it
Be careful not to rip the cable ribbons that are attached to the logic board and casing
Step 6
- Use the flat end of the plastic opening tool to unclip the cable ribbon from the logic board
Use the flat end of the plastic opening tool to unclip the cable ribbon from the logic board
Step 7
- You now have the top panel completely detached.
You now have the top panel completely detached.
Step 8
Camera
- Using the plastic opening tool, peel back the plastic cover that is glued on top of the camera lens.
Using the plastic opening tool, peel back the plastic cover that is glued on top of the camera lens.
Step 9
- Using the plastic opening tool, gently push the camera out from the front.
- Part of the foam holding the camera will rip from the adhesive.
Using the plastic opening tool, gently push the camera out from the front.
Part of the foam holding the camera will rip from the adhesive.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
C Miller
Member since: 06/25/2012
56 Reputation
3 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 1-3, Regan SU 2012
Member of Cal Poly, Team 1-3, Regan SU 2012
CPSU-REGAN-SU12S1G3
2 Members
14 Guides authored
