Difficulty

Easy

Steps

4

Time Required

                          15 minutes

Sections

1

  • Back Casing
  • 4 steps

Flags

0

  • BackMotorola Moto Q

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Casing
  • Use the Push Pin to remove the rubber screw covers by pushing the needle into the rubber and pulling up.
  • Be careful not to poke yourself when handling the push pin because it is very sharp.

Use the Push Pin to remove the rubber screw covers by pushing the needle into the rubber and pulling up.

Be careful not to poke yourself when handling the push pin because it is very sharp.

1024

Step 2

  • Use the T6 screwdriver to remove the four screws holding the casing together.
  • Note: they are in the same place where you removed the four rubber coverings

Use the T6 screwdriver to remove the four screws holding the casing together.

Note: they are in the same place where you removed the four rubber coverings

Step 3

  • Wedge the plastic opening tool in between the top and bottom cases. This may require a little or a lot of force so be careful.
  • Note: the phone should be face up and the plastic opening tool should be face downwards
  • Once you get the plastic opening tool in, slide it across the side of the phone, making sure to keep the plastic opening tool wedged in between the two casings.
  • Repeat the 3 steps above for the top, bottom, and opposite side.

Wedge the plastic opening tool in between the top and bottom cases. This may require a little or a lot of force so be careful.

Note: the phone should be face up and the plastic opening tool should be face downwards

Once you get the plastic opening tool in, slide it across the side of the phone, making sure to keep the plastic opening tool wedged in between the two casings.

Repeat the 3 steps above for the top, bottom, and opposite side.

Step 4

  • Gently lift and remove the back casing.

Gently lift and remove the back casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 


                    Luis Herrera

Member since: 01/21/2010

52 Reputation

                                      4 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Cal Poly, Team 16-33, Maness Winter 2010                        

                                                  Member of Cal Poly, Team 16-33, Maness Winter 2010 



                    CPSU-MANESS-W10S16G33                     


                                            4 Members                     


                                            10 Guides authored