Difficulty

Moderate

Steps

9

Time Required

                          25 minutes

Sections

3

  • Battery
  • 3 steps
  • Midframe
  • 4 steps
  • Rear Camera
  • 2 steps

Flags

0

  • BackMotorola Moto G4 Play

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Open case with a plastic opening tool that has the same size as the divot located at the bottom left of the phone. If you don’t have an opening tool, use your finger nails.

Open case with a plastic opening tool that has the same size as the divot located at the bottom left of the phone. If you don’t have an opening tool, use your finger nails.

1024

Step 2

  • Lift the case by the nearest corner to the divot and remove it from the phone.

Lift the case by the nearest corner to the divot and remove it from the phone.

Step 3

  • Place the plastic opening tool into the notch located at the bottom of the battery compartment, and lift upwards. If you don’t have an opening tool, use your finger nails.
  • Remove battery from your phone.

Place the plastic opening tool into the notch located at the bottom of the battery compartment, and lift upwards. If you don’t have an opening tool, use your finger nails.

Remove battery from your phone.

Step 4

              Midframe
  • Remove any SIM card and/or memory card present using your hand.

Remove any SIM card and/or memory card present using your hand.

Step 5

  • Remove the small silicon cover at the bottom right of the camera using tweezers.

Remove the small silicon cover at the bottom right of the camera using tweezers.

Step 6

  • Remove the sixteen (16) 3mm Phillips PH000 screws securing the midframe.
  • Some phones have two shorter screws, one on each side of the battery (double marked with orange circles at left). If your device has these shorter screws, make sure they go back in their original holes.

Remove the sixteen (16) 3mm Phillips PH000 screws securing the midframe.

Some phones have two shorter screws, one on each side of the battery (double marked with orange circles at left). If your device has these shorter screws, make sure they go back in their original holes.

Step 7

  • Remove the back panel assembly with your hands.

Remove the back panel assembly with your hands.

Step 8

              Rear Camera
  • Use the flat end of a spudger to disconnect the rear-facing camera connector from its socket on the mother board.

Use the flat end of a spudger to disconnect the rear-facing camera connector from its socket on the mother board.

Step 9

  • After detaching the connector, carefully remove the camera using tweezers. If you don’t have tweezers, use your hands.

After detaching the connector, carefully remove the camera using tweezers. If you don’t have tweezers, use your hands.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Paola Rossi

Member since: 02/15/2018

454 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team S17-G4, Boczar Spring 2018                        

                                                  Member of USF Tampa, Team S17-G4, Boczar Spring 2018 



                    USFT-BOCZAR-S18S17G4                     


                                            4 Members                     


                                            11 Guides authored