Difficulty
Moderate
Steps
7
Time Required
10 - 15 minutes
Sections
2
- Battery
- 3 steps
- Midframe
- 4 steps
Flags
0
BackMotorola Moto G4 Play
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Open case with a plastic opening tool that has the same size as the divot located at the bottom left of the phone. If you don’t have an opening tool, use your finger nails.
Open case with a plastic opening tool that has the same size as the divot located at the bottom left of the phone. If you don’t have an opening tool, use your finger nails.
1024
Step 2
- Lift the case by the nearest corner to the divot and remove it from the phone.
Lift the case by the nearest corner to the divot and remove it from the phone.
Step 3
- Place the plastic opening tool into the notch located at the bottom of the battery compartment, and lift upwards. If you don’t have an opening tool, use your finger nails.
- Remove battery from your phone.
Place the plastic opening tool into the notch located at the bottom of the battery compartment, and lift upwards. If you don’t have an opening tool, use your finger nails.
Remove battery from your phone.
Step 4
Midframe
- Remove any SIM card and/or memory card present using your hand.
Remove any SIM card and/or memory card present using your hand.
Step 5
- Remove the small silicon cover at the bottom right of the camera using tweezers.
Remove the small silicon cover at the bottom right of the camera using tweezers.
Step 6
- Remove the sixteen (16) 3mm Phillips PH000 screws securing the midframe.
- Some phones have two shorter screws, one on each side of the battery (double marked with orange circles at left). If your device has these shorter screws, make sure they go back in their original holes.
Remove the sixteen (16) 3mm Phillips PH000 screws securing the midframe.
Some phones have two shorter screws, one on each side of the battery (double marked with orange circles at left). If your device has these shorter screws, make sure they go back in their original holes.
Step 7
- Remove the back panel assembly with your hands.
Remove the back panel assembly with your hands.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Paola Rossi
Member since: 02/15/2018
454 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
USF Tampa, Team S17-G4, Boczar Spring 2018
Member of USF Tampa, Team S17-G4, Boczar Spring 2018
USFT-BOCZAR-S18S17G4
4 Members
11 Guides authored