Difficulty
Moderate
Steps
7
Time Required
45 minutes - 2 hours
Sections
1
- LCD (Frameless)
- 7 steps
Flags
2
In Progress
This guide is a work in progress. Reload periodically to see the latest changes!
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackMotorola Moto G Power (2021)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
LCD (Frameless)
- Heat up the back of the G Power with a heat gun or iOpener
- Once the adhesive has softened, insert an opening pick and slide it carefully around the perimeter of the phone to open it.
- Do not apply too much heat or pressure when prying. You risk bending the plastic back cover.
Heat up the back of the G Power with a heat gun or iOpener
Once the adhesive has softened, insert an opening pick and slide it carefully around the perimeter of the phone to open it.
Do not apply too much heat or pressure when prying. You risk bending the plastic back cover.
1024
Step 2
remove plastic cover
- Remove the 19 Phillips screws shown on the midframe.
Remove the 19 Phillips screws shown on the midframe.
Step 3
- Use a prying tool to open up the plastic cover plates.
- If you’re using a Jimmy or other metal tool, be careful to not mar the plastic.
Use a prying tool to open up the plastic cover plates.
If you’re using a Jimmy or other metal tool, be careful to not mar the plastic.
Step 4
Removing battery
- Unplug the battery connector with a spudger
- Apply 100% isopropyl alcohol to the edges of the battery. Wait one minute to let the alcohol loosen the adhesive.
- Pry the battery up carefully. Remove & set aside.
Unplug the battery connector with a spudger
Apply 100% isopropyl alcohol to the edges of the battery. Wait one minute to let the alcohol loosen the adhesive.
Pry the battery up carefully. Remove & set aside.
Step 5
remove lcd
- heat lcd(can use decent amount of heat to remove)
- insert opening tool and slide around the perimeter of the LCD to slice the adhesive
- clean off old adhesive, then apply new glue(either double sided sticky tape or adhesive)
heat lcd(can use decent amount of heat to remove)
insert opening tool and slide around the perimeter of the LCD to slice the adhesive
clean off old adhesive, then apply new glue(either double sided sticky tape or adhesive)
Step 6
- plug in new LCD cable
- insert battery and plug in the battery connector
plug in new LCD cable
insert battery and plug in the battery connector
Step 7
put phone back together
- put plastic covers on and screw them in
- remove most of the old adhesive
- apply either double sided sticky tape or adhesive glue and put the plastic back cover on
- if it is not sitting well try to heat it up and press it in a phone press or in between heavy books
put plastic covers on and screw them in
remove most of the old adhesive
apply either double sided sticky tape or adhesive glue and put the plastic back cover on
if it is not sitting well try to heat it up and press it in a phone press or in between heavy books
You did it!
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
ryley niemi
Member since: 02/05/2021
94 Reputation
2 Guides authored
Badges:
2