Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

2

  • Back Panel
  • 3 steps
  • Fingerprint Sensor
  • 4 steps

Flags

Grammar Police

Embrace your inner English teacher and help improve this guide’s grammar!

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackMotorola Moto G Power (2020)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Step 1

              Back Panel
  • Place a suction cup on the back of the device.
  • Open up the back of the device by sliding the opening pick into both sides of the phone.
  • Do not remove the back panel completely; you must disconnect the fingerprint sensor first.

Place a suction cup on the back of the device.

Open up the back of the device by sliding the opening pick into both sides of the phone.

Do not remove the back panel completely; you must disconnect the fingerprint sensor first.

1024

Step 2

  • Put pressure on the fingerprint sensor with your finger to detach it from the back panel.
  • You may have to use significant force to get the circular sensor off the panel.

Put pressure on the fingerprint sensor with your finger to detach it from the back panel.

You may have to use significant force to get the circular sensor off the panel.

Step 3

              Remove the cover
  • Completely remove the back panel from the device.

Completely remove the back panel from the device.

Step 4

              Fingerprint Sensor
  • You must remove the back cover of the phone to access the fingerprint sensor
  • Using T3 Screwdriver, take out total of 9 screws(about 2.2mm Torx)

You must remove the back cover of the phone to access the fingerprint sensor

Using T3 Screwdriver, take out total of 9 screws(about 2.2mm Torx)

Step 5

  • Remove the back cover using the spudger
  • You may need to leverage against the conner to lift up the cover
  • Carefully place the cover in a safe place
  • DO NOT use excessive force when lifting up the back cover. You might damage other component of the device

Remove the back cover using the spudger

You may need to leverage against the conner to lift up the cover

Carefully place the cover in a safe place

DO NOT use excessive force when lifting up the back cover. You might damage other component of the device

Step 6

  • Disconnect the fingerprint sensor from the logic board of the device
  • Use spudger to lift up the cable to disconnect the fingerprint sensor
  • WARNING: Be careful when handling the sensor cable, it’s one of the easiest component to be damaged

Disconnect the fingerprint sensor from the logic board of the device

Use spudger to lift up the cable to disconnect the fingerprint sensor

WARNING: Be careful when handling the sensor cable, it’s one of the easiest component to be damaged

Step 7

  • Finally, take out the fingerprint sensor from the device!

Finally, take out the fingerprint sensor from the device!

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Harry Jung

Member since: 06/23/2022

634 Reputation

                                      4 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UC Santa Barbara, Team 1-1, Bator Summer 2022                        

                                                  Member of UC Santa Barbara, Team 1-1, Bator Summer 2022 



                    UCSB-BATOR-SU22S1G1                     


                                            1 Member                     


                                            5 Guides authored