Motorola Moto E6 Play Circuit Board Covers Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Back Cover
1 step
Circuit Board Covers
4 steps

Flags

BackMotorola Moto E6 Play
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover

Run the halberd spudger along the edges of the device. The back cover should easily pop off.
Gently remove the back cover. Do not pull hard, as it is still connected to the fingerprint scanner inside the phone.

Run the halberd spudger along the edges of the device. The back cover should easily pop off.

Gently remove the back cover. Do not pull hard, as it is still connected to the fingerprint scanner inside the phone.

1024

Step 2

              Circuit Board Covers

To remove the cover on the motherboard, remove the 10 silver 3.90 mm Phillips screws attaching the cover to the board using the Phillips #0 screwdriver.
One of these ten screws is covered by black tape located at the bottom left corner of the black cover. Peel back the black tape to access this screw.

To remove the cover on the motherboard, remove the 10 silver 3.90 mm Phillips screws attaching the cover to the board using the Phillips #0 screwdriver.

One of these ten screws is covered by black tape located at the bottom left corner of the black cover. Peel back the black tape to access this screw.

Step 3

With the angled tweezers, remove the black cover to reveal the motherboard underneath.
Remove the black piece cover with caution to avoid puncturing the motherboard with the tweezers.

With the angled tweezers, remove the black cover to reveal the motherboard underneath.

Remove the black piece cover with caution to avoid puncturing the motherboard with the tweezers.

Step 4

The bottom plastic piece covering the daughterboard can be seen by peeling back the tape covering the bottom section of the phone below the battery.
To remove the cover, unscrew the six black 3.45 mm Phillips screws holding the cover in place using the Phillips #0 screwdriver.

The bottom plastic piece covering the daughterboard can be seen by peeling back the tape covering the bottom section of the phone below the battery.

To remove the cover, unscrew the six black 3.45 mm Phillips screws holding the cover in place using the Phillips #0 screwdriver.

Step 5

Remove the black cover piece using the angled tweezers.

Remove the black cover piece using the angled tweezers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Charlie Priebe

Member since: 02/10/2020

803 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Cal Poly, Team S22-G4, Regan Winter 2020                        

                                                  Member of Cal Poly, Team S22-G4, Regan Winter 2020 



                    CPSU-REGAN-W20S22G4                     


                                            4 Members                     


                                            14 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team