Difficulty
Moderate
Steps
6
Time Required
10 - 25 minutes
Sections
3
- Back Cover
- 1 step
- Battery
- 1 step
- Motherboard
- 4 steps
Flags
0
BackMotorola Moto E6
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Begin by prying open the bottom right of the device using the plastic opening tool.
- Work your way around the edge of the device, slowly prying open the casing until it pops off.
Begin by prying open the bottom right of the device using the plastic opening tool.
Work your way around the edge of the device, slowly prying open the casing until it pops off.
1024
Step 2
Battery
- Use the opening tool on the divot located below the battery to pop it out.
Use the opening tool on the divot located below the battery to pop it out.
Step 3
Motherboard
- Remove the eleven 3.8 mm T4 Torx screws located above the battery compartment.
Remove the eleven 3.8 mm T4 Torx screws located above the battery compartment.
Step 4
- Use the plastic opening tools to pry open the piece located at the top of the device.
- Start by prying open the side of the compartment and work your way towards the camera module, prying open the compartment as you go.
- Pop off the piece above the battery compartment.
Use the plastic opening tools to pry open the piece located at the top of the device.
Start by prying open the side of the compartment and work your way towards the camera module, prying open the compartment as you go.
Pop off the piece above the battery compartment.
Step 5
- Remove the two 1.1 mm T4 Torx screws from the bottom left and top right sides of the motherboard.
Remove the two 1.1 mm T4 Torx screws from the bottom left and top right sides of the motherboard.
Step 6
- Remove the two press fit cables at the bottom of the motherboard with the plastic opening tool.
- Remove the coaxial cable using the plastic opening tool.
- After removing the cables, remove the motherboard from the phone by hand.
Remove the two press fit cables at the bottom of the motherboard with the plastic opening tool.
Remove the coaxial cable using the plastic opening tool.
After removing the cables, remove the motherboard from the phone by hand.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Matthew Zelten
Member since: 01/23/2020
408 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team S2-G3, White Winter 2020
Member of Cal Poly, Team S2-G3, White Winter 2020
CPSU-WHITE-W20S2G3
4 Members
10 Guides authored