Difficulty
Moderate
Steps
7
Time Required
40 minutes
Sections
4
- Back Cover
- 1 step
- Battery
- 1 step
- Charging Dock
- 4 steps
- Haptic Feedback Motor
- 1 step
Flags
0
BackMotorola Moto E6
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Begin by prying open the bottom right of the device using the plastic opening tool.
- Work your way around the edge of the device, slowly prying open the casing until it pops off.
Begin by prying open the bottom right of the device using the plastic opening tool.
Work your way around the edge of the device, slowly prying open the casing until it pops off.
1024
Step 2
Battery
- Use the opening tool on the divot located below the battery to pop it out.
Use the opening tool on the divot located below the battery to pop it out.
Step 3
Charging Dock
- Remove the seven 3.8 mm T4 screws on the piece located below the battery compartment.
Remove the seven 3.8 mm T4 screws on the piece located below the battery compartment.
Step 4
- Begin prying off the bottom piece with the opening tools on the divot located at the bottom left.
- Work your way around the piece until it pops off.
Begin prying off the bottom piece with the opening tools on the divot located at the bottom left.
Work your way around the piece until it pops off.
Step 5
- Remove the press fit cable at the top of the charging dock with the plastic opening tool.
- Remove the coaxial cable using the plastic opening tool.
Remove the press fit cable at the top of the charging dock with the plastic opening tool.
Remove the coaxial cable using the plastic opening tool.
Step 6
- Remove the two 1.1 mm T4 Torx screws on the bottom right and top left sides of the charging dock.
- Remove the charging dock by hand.
Remove the two 1.1 mm T4 Torx screws on the bottom right and top left sides of the charging dock.
Remove the charging dock by hand.
Step 7
Haptic Feedback Motor
- Using tweezers, gently lift the haptic feedback motor out of its position in the bottom left corner of the device.
Using tweezers, gently lift the haptic feedback motor out of its position in the bottom left corner of the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Justin Brannon
Member since: 09/16/2020
73 Reputation
1 Guide authored
Badges:
2
Team
The Citadel Military College of South Carolina, Team S2-G16, Eggleston Fall 2020
Member of The Citadel Military College of South Carolina, Team S2-G16, Eggleston Fall 2020
CMCSC-EGGLESTON-F20S2G16
3 Members
5 Guides authored