Difficulty
Moderate
Steps
8
Time Required
15 - 30 minutes
Sections
4
- Back Cover
- 1 step
- Battery
- 1 step
- Motherboard
- 4 steps
- Front Facing Camera
- 2 steps
Flags
0
BackMotorola Moto E6
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Begin by prying open the bottom right of the device using the plastic opening tool.
- Work your way around the edge of the device, slowly prying open the casing until it pops off.
Begin by prying open the bottom right of the device using the plastic opening tool.
Work your way around the edge of the device, slowly prying open the casing until it pops off.
1024
Step 2
Battery
- Use the opening tool on the divot located below the battery to pop it out.
Use the opening tool on the divot located below the battery to pop it out.
Step 3
Motherboard
- Remove the eleven 3.8 mm T4 Torx screws located above the battery compartment.
Remove the eleven 3.8 mm T4 Torx screws located above the battery compartment.
Step 4
- Use the plastic opening tools to pry open the piece located at the top of the device.
- Start by prying open the side of the compartment and work your way towards the camera module, prying open the compartment as you go.
- Pop off the piece above the battery compartment.
Use the plastic opening tools to pry open the piece located at the top of the device.
Start by prying open the side of the compartment and work your way towards the camera module, prying open the compartment as you go.
Pop off the piece above the battery compartment.
Step 5
- Remove the two 1.1 mm T4 Torx screws from the bottom left and top right sides of the motherboard.
Remove the two 1.1 mm T4 Torx screws from the bottom left and top right sides of the motherboard.
Step 6
- Remove the two press fit cables at the bottom of the motherboard with the plastic opening tool.
- Remove the coaxial cable using the plastic opening tool.
- After removing the cables, remove the motherboard from the phone by hand.
Remove the two press fit cables at the bottom of the motherboard with the plastic opening tool.
Remove the coaxial cable using the plastic opening tool.
After removing the cables, remove the motherboard from the phone by hand.
Step 7
Front Facing Camera
- Remove the press fit cable holding the camera on the back of the motherboard using the plastic opening tool.
Remove the press fit cable holding the camera on the back of the motherboard using the plastic opening tool.
Step 8
- Peel off the adhesive sticker tape holding the front facing camera using tweezers and remove the camera from the phone.
Peel off the adhesive sticker tape holding the front facing camera using tweezers and remove the camera from the phone.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Alex Fontes
Member since: 01/23/2020
103 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
Cal Poly, Team S2-G3, White Winter 2020
Member of Cal Poly, Team S2-G3, White Winter 2020
CPSU-WHITE-W20S2G3
4 Members
10 Guides authored