Difficulty
Very easy
Steps
2
Time Required
5 - 10 minutes
Sections
- Back Cover
- 1 step
- Battery
- 1 step
Flags
0
BackMotorola Moto E6
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Begin by prying open the bottom right of the device using the plastic opening tool.
- Work your way around the edge of the device, slowly prying open the casing until it pops off.
Begin by prying open the bottom right of the device using the plastic opening tool.
Work your way around the edge of the device, slowly prying open the casing until it pops off.
1024
Step 2
Battery
- Use the opening tool on the divot located below the battery to pop it out.
Use the opening tool on the divot located below the battery to pop it out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 4 other contributors
Matthew Zelten
Member since: 01/23/2020
408 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team S2-G3, White Winter 2020
Member of Cal Poly, Team S2-G3, White Winter 2020
CPSU-WHITE-W20S2G3
4 Members
10 Guides authored
Da QBee - Nov 26, 2020
Reply
When I try to power my phone on, it shows a robot and words. How do I fix this?
Donna Baillod - May 30, 2021
Reply
If I had known it’d take two steps I would have put the new battery in weeks ago! lol Currently waiting for the phone to dip under 10% before charging it. The steps are very easy and understandable.
Oh I want everyone to be aware this tool plastic opening tool, the ends are sharp! I was very lucky it wasn’t deep, just very shallow. I used a towel so I don’t scratch the table and keep the phone safe since it has glass.
I’ll report back once the battery fully charges. I hope it goes well! I need the phone working because it’s the only phone I have.
Doug Grinbergs - Oct 30, 2021
Reply
Who’s got great advice on opening super-stubborn case? Trying a few different plastic pry tools. (:-( (One is showing signs of plastic stress.)