Difficulty
Moderate
Steps
6
Time Required
5 minutes
Sections
2
- Rear Cover
- 4 steps
- O-Ring
- 2 steps
Flags
0
BackMotorola Moto 360
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Cover
- Set the watch face down on a flat surface.
- Place the heated iOpener on the face of the rear cover to loosen the adhesive underneath.
Set the watch face down on a flat surface.
Place the heated iOpener on the face of the rear cover to loosen the adhesive underneath.
1024
Step 2
Remove the back cover without force
- Follow the instructions here to remove the back cover without force by using some needles in the right places:
- Motorola Moto 360 Case Locking Fastener Replacement
- Then continue with step 5. Or don’t use needles and just continue with the next steps.
Follow the instructions here to remove the back cover without force by using some needles in the right places:
Motorola Moto 360 Case Locking Fastener Replacement
Then continue with step 5. Or don’t use needles and just continue with the next steps.
Step 3
- Gently slide the blue opening pick between the rear cover and the metal casing.
- The rear cover is extremely fragile. Be very delicate when using the opening pick.
- Work your way entirely around the rear cover.
- It may take several attempts of reheating the adhesive to get the rear cover loose enough to pull off.
Gently slide the blue opening pick between the rear cover and the metal casing.
The rear cover is extremely fragile. Be very delicate when using the opening pick.
Work your way entirely around the rear cover.
It may take several attempts of reheating the adhesive to get the rear cover loose enough to pull off.
Step 4
- Once the adhesive has been successfully loosened, gently pull the rear cover off.
Once the adhesive has been successfully loosened, gently pull the rear cover off.
Step 5
O-Ring
- To get to the O-Ring, use the Jimmy to gently pry off the rear housing.
To get to the O-Ring, use the Jimmy to gently pry off the rear housing.
Step 6
- Pinch the green rubber O-Ring and slide it off of the watch.
- The O-Ring is delicate and is easily severed. Use care around sharp objects.
Pinch the green rubber O-Ring and slide it off of the watch.
The O-Ring is delicate and is easily severed. Use care around sharp objects.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Jake Steinorth
Member since: 01/30/2015
149 Reputation
1 Guide authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 17-32, Amido Winter 2015
Member of Cal Poly, Team 17-32, Amido Winter 2015
CPSU-AMIDO-W15S17G32
4 Members
18 Guides authored
James S - May 17, 2016
Reply
Where can you get your hands on a replacement o’ring?!
Simon Hölz - Aug 4, 2017
Reply
I broke my o-ring. Any ideas where I could get a raplacement?
cahyanto emanuel nur - Dec 15, 2017
Reply
i think you should not take the o ring. i was replaceing the battery without take the O ring