Difficulty
Easy
Steps
5
Time Required
5 minutes
Sections
2
- Wrist Strap
- 3 steps
- Case Locking Fasteners
- 2 steps
Flags
1
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackMotorola Moto 360
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Note: the guide for removing the strap shows a watch with the back cover ripped off. Don’t do it! Just remove the strap and go to the next step.
What you need
Step 1
Wrist Strap
- Locate the spring-loaded pin that attaches the wrist strap to the watch.
- There is a tiny groove on the end of the pin. This is where you will place the tweezers.
Locate the spring-loaded pin that attaches the wrist strap to the watch.
There is a tiny groove on the end of the pin. This is where you will place the tweezers.
1024
Step 2
- Take care not to lose the spring-loaded pin when removing the strap.
- Use the tweezers to compress the spring-loaded pin so the strap can be removed.
Take care not to lose the spring-loaded pin when removing the strap.
Use the tweezers to compress the spring-loaded pin so the strap can be removed.
Step 3
- Pull the wristband away from the watch face.
Pull the wristband away from the watch face.
Step 4
Case Locking Fasteners
- Locate the rectangular end of the fastener inside the wrist strap mounting pocket.
Locate the rectangular end of the fastener inside the wrist strap mounting pocket.
Step 5
- Push the point of the pin in behind the fastener and pry it out. There is a notch near the end of the fastener which will engage the pin. Once the end pops out, the fastener will slide out of the slot easliy. Repeat to remove all four of them.
- That’s it. Now the two halves of the watch can be easily separated by just pulling gently with your fingers.
Push the point of the pin in behind the fastener and pry it out. There is a notch near the end of the fastener which will engage the pin. Once the end pops out, the fastener will slide out of the slot easliy. Repeat to remove all four of them.
That’s it. Now the two halves of the watch can be easily separated by just pulling gently with your fingers.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
18 other people completed this guide.
Author
with 1 other contributor
Chris K.
Member since: 02/27/2017
661 Reputation
1 Guide authored
Badges:
7
+4 more badges
thiagopimenta - Apr 7, 2017
Reply
I lost my fasteners… where can I buy more?
Дмитрий Трубин (Dmitry Trubin) - Apr 8, 2017
Reply
One misleading thing about this guide: pictures show the back cover taken off, while in fact you don’t need to do this – just take out the fasteners.
Ethan Duffy - Aug 4, 2017
Absolutely correct, you don’t need to heat or take the back off. I will say though that getting those clips out was damnably fiddly for me.
abellegarde - Jun 16, 2017
Reply
ou peut acheter Case Locking Fastener Replacement pour moto360 mon bracelet tien pas
svp chez besoin case locking fastener
davidlanchart - Feb 11, 2018
Reply
don’t remove the back!
follow this video for removing the locking pins.
I did it, so can you!
