Difficulty
Moderate
Steps
6
Time Required
10 minutes
Sections
1
- Camera Stand
- 6 steps
Flags
0
BackMotorola MBP667CONNECT
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Camera Stand
- Remove two 5 mm Phillips #1 screws from the bottom of the camera stand.
Remove two 5 mm Phillips #1 screws from the bottom of the camera stand.
1024
Step 2
- Use a nylon spudger to remove the casing.
Use a nylon spudger to remove the casing.
Step 3
- Remove the two 5 mm Phillips #1 screws attached to the black plastic under the casing.
Remove the two 5 mm Phillips #1 screws attached to the black plastic under the casing.
Step 4
- Remove the black circular plastic part.
Remove the black circular plastic part.
Step 5
- Remove the white plastic wire housing beneath the black plastic.
Remove the white plastic wire housing beneath the black plastic.
Step 6
- Now, remove the bottom of the stand by pulling it from the camera.
Now, remove the bottom of the stand by pulling it from the camera.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Anne Ngo
Member since: 01/16/2019
183 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
Eastern Washington University, Team S1-G6, Crawford Winter 2019
Member of Eastern Washington University, Team S1-G6, Crawford Winter 2019
EWU-CRAWFORD-W19S1G6
4 Members
4 Guides authored