Difficulty
Easy
Steps
13
Time Required
10 minutes
Sections
2
- Lower Case
- 7 steps
- Speakers
- 6 steps
Flags
1
Missing Details
Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.
BackMotorola Lapdock 100
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Lower Case
- To take off the Keyboard there are three tabs at the top of the Keyboard in the locations shown in the picture that you must press and unclip. They are located behind each of the keys that are removed.
- You do not need to remove any keys to unclip the keyboard. We did this for picture purposes only.
To take off the Keyboard there are three tabs at the top of the Keyboard in the locations shown in the picture that you must press and unclip. They are located behind each of the keys that are removed.
You do not need to remove any keys to unclip the keyboard. We did this for picture purposes only.
1024
Step 2
- You can use a small metal spudger to depress each tab to avoid scratching the keyboard.
You can use a small metal spudger to depress each tab to avoid scratching the keyboard.
Step 3
- Lift up keyboard so that you are able to see the ribbon cable connected to the contact.
Lift up keyboard so that you are able to see the ribbon cable connected to the contact.
Step 4
- Flip up the ZIF connector holding the ribbon cable on the contact as shown in the two pictures and then gently disconnect the ribbon cable.
Flip up the ZIF connector holding the ribbon cable on the contact as shown in the two pictures and then gently disconnect the ribbon cable.
Step 5
- After we remove the Keyboard, you can clearly see the screws under it. Remove the ten 3mm long phillips head screws.
After we remove the Keyboard, you can clearly see the screws under it. Remove the ten 3mm long phillips head screws.
Step 6
- Flip over the Lapdock and remove the four 3.5mm long phillips head screws from the bottom.
Flip over the Lapdock and remove the four 3.5mm long phillips head screws from the bottom.
Step 7
- Use a plastic prying tool to take off the bottom case. Make sure that all of the clips are unclipped before trying to remove the case.
Use a plastic prying tool to take off the bottom case. Make sure that all of the clips are unclipped before trying to remove the case.
Step 8
Speakers
- Remove the two 2mm long phillips head screws from each speaker.
Remove the two 2mm long phillips head screws from each speaker.
Step 9
- Insert wisdom here.
Insert wisdom here.
Step 10
- Unplug speakers from master chip.
Unplug speakers from master chip.
Step 11
- Unhook each speaker wire from the tabs that are holding them in place.
Unhook each speaker wire from the tabs that are holding them in place.
Step 12
Step 13
- Gently unplug the speaker connection from the motherboard.
Gently unplug the speaker connection from the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Anthony Aiumu
Member since: 01/12/2016
764 Reputation
7 Guides authored
Badges:
8
+5 more badges
Team
Eastern Washington University, Team 1-3, Rowley Winter 2016
Member of Eastern Washington University, Team 1-3, Rowley Winter 2016
EWU-ROWLEY-W16S1G3
4 Members
8 Guides authored
