Motorola Lapdock 100 Battery Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          15 minutes

Sections

Lower Case
7 steps
Battery
2 steps

Flags

BackMotorola Lapdock 100
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Lower Case

To take off the Keyboard there are three tabs at the top of the Keyboard in the locations shown in the picture that you must press and unclip. They are located behind each of the keys that are removed.
You do not need to remove any keys to unclip the keyboard. We did this for picture purposes only.

To take off the Keyboard there are three tabs at the top of the Keyboard in the locations shown in the picture that you must press and unclip. They are located behind each of the keys that are removed.

You do not need to remove any keys to unclip the keyboard. We did this for picture purposes only.

1024

Step 2

You can use a small metal spudger to depress each tab to avoid scratching the keyboard.

You can use a small metal spudger to depress each tab to avoid scratching the keyboard.

Step 3

Lift up keyboard so that you are able to see the ribbon cable connected to the contact.

Lift up keyboard so that you are able to see the ribbon cable connected to the contact.

Step 4

Flip up the ZIF connector holding the ribbon cable on the contact as shown in the two pictures and then gently disconnect the ribbon cable.

Flip up the ZIF connector holding the ribbon cable on the contact as shown in the two pictures and then gently disconnect the ribbon cable.

Step 5

After we remove the Keyboard, you can clearly see the screws under it. Remove the ten 3mm long phillips head screws.

After we remove the Keyboard, you can clearly see the screws under it. Remove the ten 3mm long phillips head screws.

Step 6

Flip over the Lapdock and remove the four 3.5mm long phillips head screws from the bottom.

Flip over the Lapdock and remove the four 3.5mm long phillips head screws from the bottom.

Step 7

Use a plastic prying tool to take off the bottom case. Make sure that all of the clips are unclipped before trying to remove the case.

Use a plastic prying tool to take off the bottom case. Make sure that all of the clips are unclipped before trying to remove the case.

Step 8

              Battery

Unplug battery from motherboard.

Unplug battery from motherboard.

Step 9

Remove the battery.

Remove the battery.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 3 other contributors

                    Anthony Aiumu

Member since: 01/12/2016

764 Reputation

                                      7 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Eastern Washington University, Team 1-3, Rowley Winter 2016                        

                                                  Member of Eastern Washington University, Team 1-3, Rowley Winter 2016 



                    EWU-ROWLEY-W16S1G3                     


                                            4 Members                     


                                            8 Guides authored

Justin Craig - Sep 17, 2017

where can i buy a bettery

Introduction#

What you need#

Team#

Introduction

What you need

Team