Motorola Hyper Android Phone Charging Port Replacement Repair Guide

Difficulty

Moderate

Steps

13

Time Required

                          45 minutes            

Sections

1

• Charging port
• 13 steps

Flags

3

Bullets!

Better coordination with markups and the color/type of bullets will help make this guide more clear!

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackMotorola Phone

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Finding the seam  to remove.               

• Charging port replacement

Charging port replacement

1024

Step 2

              Teardown - Remove sim tray               

• Use a heat gun or hair dryer to soften the adhesive on the rear cover

Use a heat gun or hair dryer to soften the adhesive on the rear cover

Step 3

• Start at the camera and go around the edge with an Opening Pick. Pry the last bit around the camera.

Start at the camera and go around the edge with an Opening Pick. Pry the last bit around the camera.

Step 4

              Opening cover               

• Open case from the on button side face down. You will need a T4 bit driver.

Open case from the on button side face down. You will need a T4 bit driver.

Step 5

              Remove  screws for vent               

• Remove 6 T4 screws. Remove mini fan vent.

Remove 6 T4 screws. Remove mini fan vent.

Step 6

              Remove charging wires               

• Pry off the black and white wires with a pry tool. Remove Philips screw.

Pry off the black and white wires with a pry tool. Remove Philips screw.

Step 7

              Remove charge port               

• Remove and replace the charge port with new one.

Remove and replace the charge port with new one.

Step 8

              Assembly               

• Install items in reverse order

Install items in reverse order

Step 9

              Remove old gasket material               

• Clean all the gasket off.
• There is only room for one layer, for a smooth cover fit.

Clean all the gasket off.

There is only room for one layer, for a smooth cover fit.

Step 10

              Remove finger print reader cable               

• Remove finger print reader cable to install new cover gasket. surface must be clean so the cover sits tight with no gaps.

Remove finger print reader cable to install new cover gasket. surface must be clean so the cover sits tight with no gaps.

Step 11

              Install gasket               

• Make sure the gasket is firmly in place.

Make sure the gasket is firmly in place.

Step 12

              Replace FPR cable               

• Install FPR cable.
• Install the keep.
• Put tape on the cover to align the edges.

Install FPR cable.

Install the keep.

Put tape on the cover to align the edges.

Step 13

              Finish installing cover               

• Tape helps align cover for a smooth install.
• Press the cover on to seal.

Tape helps align cover for a smooth install.

Press the cover on to seal.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    wes zab                     

Member since: 06/20/2022

217 Reputation

                                      1 Guide authored                  



                       Badges:
                       3