Difficulty
Moderate
Steps
6
Time Required
Suggest a time??
Sections
3
- Rear Case
- 2 steps
- Midframe
- 3 steps
- Vibrator
- 1 step
Flags
0
BackMotorola Droid Turbo
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Case
- Prepare an iOpener and lay it over the rear case to soften the adhesive on securing the rear case to the phone.
Prepare an iOpener and lay it over the rear case to soften the adhesive on securing the rear case to the phone.
1024
Step 2
- Use a plastic opening tool to pry the rear case off of the rest of the device.
- Remove the rear case.
- The wireless charging coil may try to stick to the rear case, so make sure to remove it from the case before fully separating the rear case from the rest of the device.
Use a plastic opening tool to pry the rear case off of the rest of the device.
Remove the rear case.
The wireless charging coil may try to stick to the rear case, so make sure to remove it from the case before fully separating the rear case from the rest of the device.
Step 3
Midframe
- Remove the midframe bezel.
Remove the midframe bezel.
Step 4
- Remove the four Torx T5 screws securing the midframe plate.
Remove the four Torx T5 screws securing the midframe plate.
Step 5
- Remove the midframe.
Remove the midframe.
Step 6
Vibrator
- Use the pointed end of a spudger to gently pry the vibrator up and away from the midframe.
Use the pointed end of a spudger to gently pry the vibrator up and away from the midframe.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
Geoff Wacker
Member since: 09/30/2013
87,546 Reputation
89 Guides authored
Badges:
44
+41 more badges