Difficulty

Moderate

Steps

9

Time Required

                          9 minutes

Sections

2

  • Battery
  • 7 steps
  • Front Camera
  • 2 steps

Flags

1

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackMotorola Droid MAXX 2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Insert a small pointed object into the hole on the sim card tray to eject the tray from the phone.

Insert a small pointed object into the hole on the sim card tray to eject the tray from the phone.

1024

Step 2

  • Pull the sim card tray up out of the phone

Pull the sim card tray up out of the phone

Step 3

  • Wedge your thumb into the indent located on the bottom left corner of the back cover and pull up to remove the back cover.

Wedge your thumb into the indent located on the bottom left corner of the back cover and pull up to remove the back cover.

Step 4

  • Remove the seventeen 3.2mm Torx T4 screws from the mid-frame.
  • These may be T3 screws. If you are having trouble unscrewing these, stop and try a T3 bit.

Remove the seventeen 3.2mm Torx T4 screws from the mid-frame.

These may be T3 screws. If you are having trouble unscrewing these, stop and try a T3 bit.

Step 5

  • Pull the mid-frame off of the phone.
  • Keep track of the on/off and volume buttons when you take the phone apart because they are likely to fall out when the halves are separated.

Pull the mid-frame off of the phone.

Keep track of the on/off and volume buttons when you take the phone apart because they are likely to fall out when the halves are separated.

Step 6

  • Remove the static tape covering the two connectors.
  • Use a spudger to disconnect the battery cables from the motherboard.
  • If battery has adhesive, use heat gun for one to two minutes to loosen it. Be careful of the points outlined in red when prying it up. Use guitar picks or a spudger to gently lift the battery and separate the adhesive.

Remove the static tape covering the two connectors.

Use a spudger to disconnect the battery cables from the motherboard.

If battery has adhesive, use heat gun for one to two minutes to loosen it. Be careful of the points outlined in red when prying it up. Use guitar picks or a spudger to gently lift the battery and separate the adhesive.

Step 7

  • Remove the disconnected battery from the phone.

Remove the disconnected battery from the phone.

Step 8

              Front Camera
  • Flip the camera backwards 180 degrees.

Flip the camera backwards 180 degrees.

Step 9

  • Use a spudger to lift up the black tab on the ZIF connector.
  • Remove the camera.

Use a spudger to lift up the black tab on the ZIF connector.

Remove the camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors 


                    Burke Seggerman

Member since: 03/18/2018

704 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Baylor, Team S3-G4, Williams Spring 2018                        

                                                  Member of Baylor, Team S3-G4, Williams Spring 2018 



                    BU-WILLIAMS-S18S3G4                     


                                            3 Members                     


                                            6 Guides authored