Featured

Featured Guide

Difficulty

Difficult

Steps

9

Time Required

                          20 minutes            

Sections

5

  • Rear Case
  • 1 step
  • Battery
  • 1 step
  • Front Case
  • 1 step
  • Logic Board
  • 3 steps
  • Display
  • 3 steps

Flags

2

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

This guide has been found to be exceptionally cool by the iFixit staff.

  • BackMotorola C350

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear case freeing               
  • Use your finger to press the button and free the device rear case.
  • You may have to force it a bit more to free its bottom if you open it for the first time.

Use your finger to press the button and free the device rear case.

You may have to force it a bit more to free its bottom if you open it for the first time.

1024

Step 2

              Removing battery               
  • slide the black button to free the battery so you can grab it with your other hand.

slide the black button to free the battery so you can grab it with your other hand.

Step 3

              Separating the front case               
  • You will see one plastic clip on each side of the device. Use your thumbs to push them apart and being able to separate the front case from the device other components.

You will see one plastic clip on each side of the device. Use your thumbs to push them apart and being able to separate the front case from the device other components.

Step 4

              Logic Board               
  • Remove the 4 T6 Torx screws

Remove the 4 T6 Torx screws

Step 5

  • Use a metal spudger to pell off the four metal clips and separate the motherboard and keyboard from the main plastic part.

Use a metal spudger to pell off the four metal clips and separate the motherboard and keyboard from the main plastic part.

Step 6

  • The last thing you need to doto access the Logic Board is to separate the Keyboard/Screen block just taking apart with your fingers.

The last thing you need to doto access the Logic Board is to separate the Keyboard/Screen block just taking apart with your fingers.

Step 7

              Display               
  • Remove the two small metal clips keeping the cables safe.

Remove the two small metal clips keeping the cables safe.

Step 8

  • Use a plastic spudger to pell off the two cables on the back side of the screen.
  • There are two very small connectors. Take care of them and replace them if they incidentally fall.

Use a plastic spudger to pell off the two cables on the back side of the screen.

There are two very small connectors. Take care of them and replace them if they incidentally fall.

Step 9

  • Use a plastic spudger to release the disconnected screen.

Use a plastic spudger to release the disconnected screen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    Vincent Monteil                     

Member since: 07/06/2013

6,843 Reputation

                                      19 Guides authored                  



                       Badges:
                       30







                                                        +27 more badges